pef20550 Infineon Technologies Corporation, pef20550 Datasheet - Page 238

• Manufacturer Part Number: pef20550
• Description: Extended Line Card Interface Controller Elic
• Manufacturer: Infineon Technologies Corporation

PEB 20550
PEF 20550
Application Hints
64 kBit/s channels, bits 3 … 0 for 32 kBit/s channels and bits 5 … 4 for 16 kBit/s
channels.
Since for each CFI timeslot there is only one control memory location, only one
subchannel may be mapped to each CFI timeslot. The remaining bits of such a partly
unused CFI timeslot are inactive e.g. set to high impedance if OMDR:COS = 0.
Note that if an odd numbered CFI timeslot is initialized as an IOM channel with switched
D channel, SC#1 … SC#0 must be set to ‘00’ because the D channel is located at bits
7 … 6. In this case the remaining bits can still be used for C/I and monitor channel
applications (refer to chapter 5.5).
For more detailed information on subchannel switching refer to chapter 5.4.2.
CFI Standby Mode OMDR:CSB
In standby mode (OMDR:CSB = 0), the CFI output ports are set to high impedance and
the clock signals DCL and FSC, if programmed as outputs (CMD1:CSS = 0), are
switched off.
Note that the internal operation of the ELIC is not affected in standby mode, i.e. the
received CFI data is still read in and may still be processed by the ELIC (switched to
PCM or P, etc.)
In operational mode (OMDR:CSB = 1), the CFI output pins take over the function
programmed in the control memory and DCL and FSC deliver clock and framing output
signals (if CMD1:CSS = 0) as programmed in CMD1 and CMD2.
CFI Output Driver Selection OMDR:COS
The output drivers at the configurable interface (DD# or I/O#) can be programmed as
open drain or tristate drivers.
If programmed as open drain drivers (OMDR:COS = 1), external pull-up resistors
(connected to
V
) are required in order to pull the output line to a high level if a logical
DD
1 is being transmitted. For unassigned channels (e.g. control memory code ‘0000’) the
ELIC transmits a logical 1. The maximum output current at a low voltage level of 0.45 V
is 7 mA, pull-up resistors down to 680
can thus be used.
If programmed as tristate drivers (OMDR:COS = 0), logical 0s and 1s are transmitted
with push-pull output drivers, whereas unassigned channels are set to high impedance.
Semiconductor Group
238
01.96