LPC47N227TQFP Standard Microsystems (SMSC), LPC47N227TQFP Datasheet - Page 25

• Manufacturer Part Number: LPC47N227TQFP
• Manufacturer: Standard Microsystems (SMSC)

Specifications of LPC47N227TQFP

• Lead Free Status / RoHS Status: Not Compliant

Digital Output Register (DOR)
Address 3F2 READ/WRITE
The DOR controls the drive select and motor enables of the disk interface outputs. It also contains the
enable for the DMA logic and a software reset bit. The contents of the DOR are unaffected by a software
reset. The DOR can be written to at any time.
BIT 0 and 1 DRIVE SELECT
These two bits are binary encoded for the drive selects, thereby allowing only one drive to be selected at
one time.
BIT 2 nRESET
A logic "0" written to this bit resets the Floppy disk controller. This reset will remain active until a logic "1"
is written to this bit. This software reset does not affect the DSR and CCR registers, nor does it affect the
other bits of the DOR register. The minimum reset duration required is 100ns, therefore toggling this bit by
consecutive writes to this register is a valid method of issuing a software reset.
BIT 3 DMAEN
PC/AT and Model 30 Mode:
Writing this bit to logic "1" will enable the DMA and interrupt functions. This bit being a logic "0" will
disable the DMA and interrupt functions. This bit is a logic "0" after a reset and in these modes.
PS/2 Mode: In this mode the DMA and interrupt functions are always enabled. During a reset, this bit will
be cleared to a logic "0".
BIT 4 MOTOR ENABLE 0
This bit controls the MTR0 disk interface output. A logic "1" in this bit will cause the output pin to go active.
BIT 5 MOTOR ENABLE 1
This bit controls the MTR1 disk interface output. A logic "1" in this bit will cause the output pin to go active.
RESET
COND.
MOT
EN3
7
0
MOT
EN2
6
0
MOT
EN1
5
0
MOT
EN0
25
4
0
DMAEN nRESE
3
0
T
2
0
DRIVE
SEL1
1
0
DRIVE
SEL0
0
0