D13002F16V Renesas Electronics America, D13002F16V Datasheet - Page 452

• Manufacturer Part Number: D13002F16V
• Description: IC H8/3002 ROMLESS 100QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of D13002F16V

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 16MHz
• Connectivity: SCI
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 38
• Program Memory Type: ROMless
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

Bit 3—Parity Error (PER): Indicates that data reception ended abnormally due to a parity error
in asynchronous mode.
Bit 3
PER
0
1
Notes: 1. Clearing the RE bit to 0 in SCR does not affect the PER flag, which retains its previous
Bit 2—Transmit End (TEND): Indicates that when the last bit of a serial character was
transmitted TDR did not contain new transmit data, so transmission has ended. The TEND flag is
a read-only bit and cannot be written.
Bit 2
TEND
0
1
2. When a parity error occurs the SCI transfers the receive data into RDR but does not set
Description
Receiving is in progress or has ended normally
[Clearing conditions]
The chip is reset or enters standby mode.
Software reads PER while it is set to 1, then writes 0.
A receive parity error occurred
[Setting condition]
The number of 1s in receive data, including the parity bit, does not match the even or
odd parity setting of O/E in SMR.
Description
Transmission is in progress
[Clearing conditions]
Software reads TDRE while it is set to 1, then writes 0 in the TDRE flag.
The DMAC writes data in TDR.
End of transmission
[Setting conditions]
The chip is reset or enters standby mode.
The TE bit is cleared to 0 in SCR.
TDRE is 1 when the last bit of a serial character is transmitted.
value.
the RDRF flag. Serial receiving cannot continue while the PER flag is set to 1. In
synchronous mode, serial transmitting is also disabled.
*2
436
*1
(Initial value)
(Initial value)