M3062PT3-RPD-E Renesas Electronics America, M3062PT3-RPD-E Datasheet - Page 72

• Manufacturer Part Number: M3062PT3-RPD-E
• Description: EMULATOR BASE UNIT FOR M16C/60
• Manufacturer: Renesas Electronics America

Specifications of M3062PT3-RPD-E

• Accessory Type: Emulation Pod
• For Use With/related Products: PC4701, M16C/60, M16C/30
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: M3062PT3-RPD#E; M3062PT3-RPD#E

REJ10J0040-0600 Rev.6.00 July 01, 2006
M3062PT3-RPD-E User’s Manual
(3) Trace points setup window
1) Trace points setup window
2) Setting the trace write condition
3) Realtime trace Write Condition dialog box
Trace Points Setting Window in initial state
window.
You can set events in the same way as for the hardware
breakpoints.
Specifying a trace range
You can specify a trace range for the trace event.
- Break
- Before
- About
- After
- Full
Setting the trace write condition
You can specify a condition for the cycles to be written into the
trace memory.
- Total
- Pick up
- Exclude
When you have finished setting the trace write condition, click
this button. The Realtime-trace Write Condition dialog box
shown below will appear.
Write mode
Only the cycle in which the specified Start event occurred.
A range of cycles from when the specified Start event occurred to
when the specified Start event became nonexistent.
A range of cycles from when the specified Start event occurred to
when the specified End event occurred.
32K cycles of instruction execution before the user program
stopped is recorded.
32K cycles of instruction execution before a trace point
condition was met is recorded.
16K cycles of instruction execution before and after a trace
point condition was met is recorded.
32K cycles of instruction execution after a trace point
condition was met is recorded.
32K cycles of instruction execution after a trace began is
recorded.
3. Usage (How to Use the Emulator Debugger)
All cycles are written into memory.
Only the cycles in which the specified condition was met are
written into memory.
Only the cycles in which the specified condition was not met
are written into memory.
Clicking this toolbar button opens the trace point setting
Page 70 of 104