M3062PT3-RPD-E Renesas Electronics America, M3062PT3-RPD-E Datasheet - Page 22

• Manufacturer Part Number: M3062PT3-RPD-E
• Description: EMULATOR BASE UNIT FOR M16C/60
• Manufacturer: Renesas Electronics America

Specifications of M3062PT3-RPD-E

• Accessory Type: Emulation Pod
• For Use With/related Products: PC4701, M16C/60, M16C/30
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: M3062PT3-RPD#E; M3062PT3-RPD#E

REJ10J0040-0600 Rev.6.00 July 01, 2006
M3062PT3-RPD-E User’s Manual
2. Setup
This chapter describes the preparation for using this product, the procedure for starting up the emulator and how to change
settings.
2.1 Flowchart of Starting Up the Emulator
The procedure for starting up the emulator is shown in Figure 2.1. For details, refer to each section hereafter. And, when the
emulator does not start up normally, refer to “5. Troubleshooting” (page 96).
Figure 2.1 Flowchart of starting up the emulator
Connect the emulation pod to the emulator.
Connect the power supply for the emulator.
Debug a program with various functions of
High-performance Embedded Workshop.
Start up the emulator debugger from the
Check the LED display of the emulator.
Install the M16C PC4701 Emulator
Check the package components.
Set the operating environment
Turning on the power supply.
Connect the host machine.
of the emulator debugger.
Connect the user system.
the emulator debugger.
User registration
Debugger.
▼
▼
▼
▼
▼
▼
▼
▼
▼
▼
▼
Refer to “1.1 Package Components” (page 13).
Refer to “User Registration” (page 11).
Install the M16C PC4701 Emulator Debugger.
Select the interface according to your PC4701 and connect the
PC4701 to the host machine with each interface connector.
Set the interface selection switch on the rear panel of the PC4701 to
the using interface.
Connect the emulation pod M3062PT3-RPD-E to the PC4701 using
the FLX120-RPD.
Connect a power supply for the emulator.
Connect the user system as occasion demands.
Turn ON the power to the emulator and the user system as
simultaneously as possible.
Check that system status LED, and POWER, CLOCK, RESET and
WARNING of target status LED are lighting. When the user system
is not connected, the POWER LED does not light up.
Start up the High-performance Embedded Workshop, and the
emulator debugger.
Set the INIT dialog box of the emulator debugger.
For how to use the High-performance Embedded Workshop and the
emulator debugger, refer to each online manual.
Page 20 of 104
2. Setup