M3062PT3-RPD-E Renesas Electronics America, M3062PT3-RPD-E Datasheet - Page 29

• Manufacturer Part Number: M3062PT3-RPD-E
• Description: EMULATOR BASE UNIT FOR M16C/60
• Manufacturer: Renesas Electronics America

Specifications of M3062PT3-RPD-E

• Accessory Type: Emulation Pod
• For Use With/related Products: PC4701, M16C/60, M16C/30
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: M3062PT3-RPD#E; M3062PT3-RPD#E

REJ10J0040-0600 Rev.6.00 July 01, 2006
M3062PT3-RPD-E User’s Manual
2.6 Downloading Firmware
2.6.1 When It is Necessary to Download Firmware
It is necessary to download the firmware in the cases listed below. Normally, the following are automatically detected when the
emulator debugger is started up, and the firmware is downloaded.
(1) When you use this product for the first time
(2) When the firmware has been upgraded
(3) When the emulator debugger has been upgraded
(4) When you use this product with a PC4701 which was used with other emulation pod before
If downloading firmware is not completed in the cases below, redownload the firmware in maintenance mode.
- When the power is unexpectedly shut down during a download from the emulator debugger
- When a communications interface cable is unexpectedly pulled out
2.6.2 Downloading Firmware in Maintenance Mode
Download the firmware in maintenance mode as explained here following. The user system must not be connected when
downloading the firmware.
(1) Set the interface select switch on the rear panel of the PC4701 to the dedicated parallel, LPT or serial interface to connect
(2) Within 2 seconds of activating power to the emulator, press the RESET switch on the PC4701 upper panel to switch to
(3) Start up the emulator debugger. When the Init dialog box setup is complete, the dialog which urges to download the
Figure 2.5 Downloading firmware in maintenance mode
Note on Downloading Firmware:
the PC4701 and the host machine. Set the interface selection switch on the rear panel of the PC4701 according to the using
interface. The firmware may not be downloaded in maintenance mode correctly with the USB interface.
maintenance mode.
Switched to maintenance mode, the SAFE SYSTEM STATUS LED begins to flash.
firmware will appear. Download the firmware following messages. Required time for downloading the firmware is about
60 seconds.
Immediately after turning on the power
PO WER
SAFE
ERROR
PO WER
SAFE
ERROR
STATUS OF
STATUS OF
Do not shut OFF power while the firmware is being downloaded. Doing so, the emulator will not start up
properly. If power is shut OFF by mistake, redownload the firmware in maintenance mode.
RESET
RESET
SYSTEM
SYSTEM
All the LEDs light
SAFE LED blinks
PO WER
CLOCK
RESET
RUN
HALT
PO WER
CLOCK
RESET
RUN
HALT
When maintenance mode started
PO W ER
SAFE
ERR OR
PO W ER
SAFE
ERR OR
STATUS OF
STATUS OF
RESET
RESET
SYSTEM
SYSTEM
IMPORTANT
SAFE LED lights
All the LEDs light
PO W ER
CLOCK
RESET
RUN
HALT
PO W ER
CLOCK
RESET
RUN
HALT
When downloading firmware started
When download complete
PO WER
SAFE
ERROR
PO WER
SAFE
ERROR
STATUS OF
STATUS OF
RESET
RESET
SYSTEM
SYSTEM
ERROR LED lights
PO WER
CLOCK
RESET
RUN
HALT
PO WER
CLOCK
RESET
RUN
HALT
: On
: Off
: Blinking
Page 27 of 104
2. Setup