M3062PT3-RPD-E Renesas Electronics America, M3062PT3-RPD-E Datasheet - Page 19

• Manufacturer Part Number: M3062PT3-RPD-E
• Description: EMULATOR BASE UNIT FOR M16C/60
• Manufacturer: Renesas Electronics America

Specifications of M3062PT3-RPD-E

• Accessory Type: Emulation Pod
• For Use With/related Products: PC4701, M16C/60, M16C/30
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: M3062PT3-RPD#E; M3062PT3-RPD#E

REJ10J0040-0600 Rev.6.00 July 01, 2006
M3062PT3-RPD-E User’s Manual
(2) Target Status LEDs
The target status LEDs indicate the target MCU's operating status and target board's power supply. Table 1.4 lists the definition
of each target status LED.
Table 1.4 Definitions of the target status LEDs
Note on the Target Status POWER LED:
Notes on the Target Status CLOCK LED:
POWER
CLOCK
RESET
HALT
Name
RUN
If the MCU has two or more Vcc terminals, the LED does not light unless power is supplied to all the
terminals.
CLOCK LED is turned off when both main and sub clocks are not oscillating. If either clock is oscillating,
the LED is turned on.
If the LED is not turned on, check the following.
(1) After powering on the PC4701 (before starting up the emulator debugger):
(2) After the emulator debugger is started up (after the Init dialog box settings are completed):
Status
OFF
OFF
OFF
OFF
OFF
ON
ON
ON
ON
ON
Make sure that the oscillator circuit board in the emulation pod is properly installed and it is oscillating
normally.
Make sure that the oscillator selected in the Init dialog box is oscillating normally.
Power is supplied to the user system.
Power is not supplied to the user system.
Target MCU clock is supplied.
Target MCU clock is not supplied.
Target MCU is being reset, or reset signal of the user system is held low.
Target MCU is not being reset.
User program is being executed.
User program has been halted.
CPU clock of target MCU is not oscillating.
CPU clock of target MCU is oscillating.
IMPORTANT
Meaning
Page 17 of 104
1. Outline