M3062PT3-RPD-E Renesas Electronics America, M3062PT3-RPD-E Datasheet - Page 56

• Manufacturer Part Number: M3062PT3-RPD-E
• Description: EMULATOR BASE UNIT FOR M16C/60
• Manufacturer: Renesas Electronics America

Specifications of M3062PT3-RPD-E

• Accessory Type: Emulation Pod
• For Use With/related Products: PC4701, M16C/60, M16C/30
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: M3062PT3-RPD#E; M3062PT3-RPD#E

REJ10J0040-0600 Rev.6.00 July 01, 2006
M3062PT3-RPD-E User’s Manual
3) Executing the self-check
Specifying the communication interface (LPT)
- For selecting the LPT communication, click the radio button “LPT” of
- For the Type area, specify the LPT interface communication mode to be
- Specify the I/O address of the parallel port at the I/O address area.
- For BIOS setup, the following addresses are available.
Specifying the communication interface (USB)
- For selecting the USB communication, click the radio button “USB” of
- The emulators connected by USB cable are shown at Serial No. area.
- Select the serial No. of the emulator you are going to connect.
Executing the self-check
Enable this function when you want the emulator to be self-checked at
startup. Be sure to select the check box only when you want the emulator to
be self-checked at startup.
Note:
In case where self-checking was normally completed, terminate the
emulator debugger once, then start operation with no self-checking
carried out again (with leaving the check box unchecked).
This function may be enabled in the following cases:
- When you are using the emulator you have just purchased and fail to
- When you successfully download the firmware, but fail to start up the
- When you want to confirm whether the emulator is operating normally
This function can be enabled only when you are starting up the emulator
debugger.
the MCU tab.
used. When you use the emulator debugger for the first time, select
“AUTO”.
the MCU tab.
download the firmware.
emulator debugger.
because, for example, the MCU runs out of control or something is
wrong with the trace results.
- 378h
- 278h
3. Usage (How to Use the Emulator Debugger)
Page 54 of 104