LPC11A14FBD48/301, NXP Semiconductors, LPC11A14FBD48/301, Datasheet - Page 66

• Manufacturer Part Number: LPC11A14FBD48/301,
• Description: ARM Microcontrollers - MCU CortexM0 32bit 32KB
• Manufacturer: NXP Semiconductors

Specifications of LPC11A14FBD48/301,

• Rohs: yes
• Core: ARM Cortex M0
• Processor Series: LPC11A
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 32 KB
• Data Ram Size: 8 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 2.6 V to 3.6 V
• Package / Case: LQFP-48
• Mounting Style: SMD/SMT
• Factory Pack Quantity: 250

NXP Semiconductors
12. Application information
LPC11AXX
Product data sheet
12.1 ADC usage notes
12.2 Use of ADC input trigger signals
12.3 XTAL input
The following guidelines show how to increase the performance of the ADC in a noisy
environment beyond the ADC specifications listed in
For applications that use trigger signals to start conversions and require a precise sample
frequency, ensure that the period of the trigger signal is an integral multiple of the period
of the ADC clock.
The input voltage to the on-chip oscillators is limited to 1.8 V. If the oscillator is driven by a
clock in slave mode, it is recommended that the input be coupled through a capacitor with
C
capacitor to ground C
mode, a minimum of 200 mV(RMS) is needed.
In slave mode the input clock signal should be coupled by means of a capacitor of 100 pF
(Figure
corresponds to a square wave signal with a signal swing of between 280 mV and 1.4 V.
The XTALOUT pin in this configuration can be left unconnected.
External components and models used in oscillation mode are shown in
Table 27
and the capacitances C
fundamental mode oscillation (the fundamental frequency is represented by L, C
Fig 29. Slave mode operation of the on-chip oscillator
•
•
•
•
i
= 100 pF. To limit the input voltage to the specified range, choose an additional
The ADC input trace must be short and as close as possible to the LPC11Axx chip.
The ADC input traces must be shielded from fast switching digital signals and noisy
power supply lines.
Because the ADC and the digital core share the same power supply, the power supply
line must be adequately filtered.
To improve the ADC performance in a very noisy environment, put the device in Sleep
mode during the ADC conversion.
29), with an amplitude between 200 mV (RMS) and 1000 mV (RMS). This
and
Table
All information provided in this document is subject to legal disclaimers.
28. Since the feedback resistance is integrated on chip, only a crystal
g
Rev. 4 — 30 October 2012
which attenuates the input voltage by a factor C
X1
and C
X2
need to be connected externally in case of
XTALIN
LPC1xxx
C i
100 pF
002aae788
32-bit ARM Cortex-M0 microcontroller
C g
Table
18:
LPC11Axx
i
/(C
© NXP B.V. 2012. All rights reserved.
Figure 30
i
+ C
g
). In slave
L
and
and in
66 of 84