HD6412350 Hitachi, HD6412350 Datasheet - Page 624

no-image

HD6412350

Manufacturer Part Number
HD6412350
Description
(HD6412350 / HD6432351) 16-BIT MICROCONTROLLER
Manufacturer
Hitachi
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
HD6412350F10
Manufacturer:
HITACHI/日立
Quantity:
20 000
Part Number:
HD6412350F20
Manufacturer:
RENESAS
Quantity:
648
Part Number:
HD6412350F20
Manufacturer:
Renesas Electronics America
Quantity:
10 000
Part Number:
HD6412350F20
Manufacturer:
ST
0
Part Number:
HD6412350F20
Manufacturer:
HITACHI/日立
Quantity:
20 000
Part Number:
HD6412350F20V
Manufacturer:
RENESAS
Quantity:
586
Part Number:
HD6412350F20V
Manufacturer:
Renesas Electronics America
Quantity:
10 000
Part Number:
HD6412350F20V
Manufacturer:
RENESAS/瑞萨
Quantity:
20 000
Part Number:
HD6412350TE20
Manufacturer:
HIT
Quantity:
1 000
Part Number:
HD6412350TE20
Manufacturer:
HITACHI/日立
Quantity:
20 000
Part Number:
HD6412350TE20IV
Manufacturer:
DALLAS
Quantity:
2 874
The operation sequence is as follows.
[1] When the data line is not in use it is in the high-impedance state, and is fixed high with a pull-
[2] The transmitting station starts transfer of one frame of data. The data frame starts with a start
[3] With the Smart Card interface, the data line then returns to the high-impedance state. The data
[4] The receiving station carries out a parity check.
[5] If the transmitting station does not receive an error signal, it proceeds to transmit the next data
604
up resistor.
bit (Ds, low-level), followed by 8 data bits (D0 to D7) and a parity bit (Dp).
line is pulled high with a pull-up resistor.
If there is no parity error and the data is received normally, the receiving station waits for
reception of the next data.
If a parity error occurs, however, the receiving station outputs an error signal (DE, low-level)
to request retransmission of the data. After outputting the error signal for the prescribed length
of time, the receiving station places the signal line in the high-impedance state again. The
signal line is pulled high again by a pull-up resistor.
frame.
If it does receive an error signal, however, it returns to step [2] and retransmits the erroneous
data.

Related parts for HD6412350