HD6412350 Hitachi, HD6412350 Datasheet - Page 299

• Manufacturer Part Number: HD6412350
• Description: (HD6412350 / HD6432351) 16-BIT MICROCONTROLLER
• Manufacturer: Hitachi

Write Data Buffer Function: When the WDBE bit of BCRL in the bus controller is set to 1,
enabling the write data buffer function, dual address transfer external write cycles or single
address transfers and internal accesses (on-chip memory or internal I/O registers) are executed in
parallel.
(a) Write Data Buffer Function and DMAC Register Setting
If the setting of is changed during execution of an external access by means of the write data
buffer function, the external access may not be performed normally. The register that controls
external accesses should only be manipulated when external reads, etc., are used with DMAC
operation disabled, and the operation is not performed in parallel with external access.
(b) Write Data Buffer Function and DMAC Operation Timing
The DMAC can start its next operation during external access using the write data buffer function.
Consequently, the DREQ pin sampling timing, TEND output timing, etc., are different from the
case in which the write data buffer function is disabled. Also, internal bus cycles maybe hidden,
and not visible.
(c) Write Data Buffer Function and TEND Output
A low level is not output from the TEND pin if the bus cycle in which a low level is to be output
from the TEND pin is an internal bus cycle, and an external write cycle is executed in parallel with
this cycle. Note, for example, that a low level may not be output from the TEND pin if the write
data buffer function is used when data transfer is performed between an internal I/O register and
on-chip memory.
If at least one of the DMAC transfer addresses is an external address, a low level is output from
the TEND pin.
279