HD6412350 Hitachi, HD6412350 Datasheet - Page 332

• Manufacturer Part Number: HD6412350
• Description: (HD6412350 / HD6432351) 16-BIT MICROCONTROLLER
• Manufacturer: Hitachi

8.5
Usage Notes
Module Stop: When the MSTP14 bit in MSTPCR is set to 1, the DTC clock stops, and the DTC
enters the module stop state. However, 1 cannot be written in the MSTP14 bit while the DTC is
operating.
On-Chip RAM: The MRA, MRB, SAR, DAR, CRA, and CRB registers are all located in on-chip
RAM. When the DTC is used, the RAME bit in SYSCR must not be cleared to 0.
DMAC Transfer End Interrupt: When DTC transfer is activated by a DMAC transfer end
interrupt, regardless of the transfer counter and DISEL bit, the DMAC’s DTE bit is not subject to
DTC control, and the write data has priority. Consequently, an interrupt request may not be sent
to the CPU when the DTC transfer counter reaches 0.
DTCE Bit Setting: For DTCE bit setting, use bit manipulation instructions such as BSET and
BCLR. If all interrupts are masked, multiple activation sources can be set at one time by writing
data after executing a dummy read on the relevant register.
312