AT83C51SND1C_03 ATMEL [ATMEL Corporation], AT83C51SND1C_03 Datasheet - Page 89

• Manufacturer Part Number: AT83C51SND1C_03
• Description: Single-Chip Flash Microcontroller with MP3 Decoder and Human Interface
• Manufacturer: ATMEL [ATMEL Corporation]

Bulk/Interrupt IN Transactions
in Standard Mode
4109E–8051–06/03
If the Host sends more Bytes than supported by the endpoint FIFO, the overflow data
won’t be stored, but the USB controller will consider that the packet is valid if the CRC is
correct.
Figure 64. Bulk/Interrupt IN Transactions in Standard Mode
An endpoint should be first enabled and configured before being able to send Bulk or
Interrupt packets.
The firmware should fill the FIFO with the data to be sent and set the TXRDY bit in the
UEPSTAX register to allow the USB controller to send the data stored in FIFO at the
next IN request concerning this endpoint. To send a Zero Length Packet, the firmware
should set the TXRDY bit without writing any data into the endpoint FIFO.
Until the TXRDY bit has been set by the firmware, the USB controller will answer a NAK
handshake for each IN requests.
To cancel the sending of this packet, the firmware has to reset the TXRDY bit. The
packet stored in the endpoint FIFO is then cleared and a new packet can be written and
sent.
When the IN packet has been sent and acknowledged by the Host, the TXCMPL bit in
the UEPSTAX register is set by the USB controller. This triggers a USB interrupt if
enabled. The firmware should clear the TXCMPL bit before filling the endpoint FIFO with
new data.
The firmware should never write more Bytes than supported by the endpoint FIFO.
All USB retry mechanisms are automatically managed by the USB controller.
IN
IN
HOST
ACK
DATA0 (n Bytes)
NAK
UFI
TXCMPL
AT8xC51SND1C
Endpoint FIFO Write Byte 1
Endpoint FIFO Write Byte 1
Endpoint FIFO Write Byte 2
Endpoint FIFO Write Byte n
Clear TXCMPL
Set TXRDY
C51
89