AT83C51SND1C_03 ATMEL [ATMEL Corporation], AT83C51SND1C_03 Datasheet - Page 80

• Manufacturer Part Number: AT83C51SND1C_03
• Description: Single-Chip Flash Microcontroller with MP3 Decoder and Human Interface
• Manufacturer: ATMEL [ATMEL Corporation]

Universal Serial Bus
USB Mass Storage Class
Bulk-Only Transport
USB Device Firmware
Upgrade (DFU)
80
AT8xC51SND1C
The AT8xC51SND1C implements a USB device controller supporting full speed data
transfer. In addition to the default control endpoint 0, it provides 2 other endpoints, which
can be configured in control, bulk, interrupt or isochronous modes:
•
•
This allows the firmware to be developed conforming to most USB device classes, for
example:
•
•
•
Within the Bulk-only framework, the Control endpoint is only used to transport class-
specific and standard USB requests for device set-up and configuration. One Bulk-out
endpoint is used to transport commands and data from the host to the device. One Bulk
in endpoint is used to transport status and data from the device to the host.
The following AT8xC51SND1C configuration adheres to those requirements:
•
•
•
The USB Device Firmware Update (DFU) protocol can be used to upgrade the on-chip
Flash memory of the AT89C51SND1C. This allows installing product enhancements
and patches to devices that are already in the field. 2 different configurations and
descriptor sets are used to support DFU functions. The Run-Time configuration co-exist
with the usual functions of the device, which is USB Mass Storage for AT89C51SND1C.
It is used to initiate DFU from the normal operating mode. The DFU configuration is
used to perform the firmware update after device re-configuration and USB reset. It
excludes any other function. Only the default control pipe (endpoint 0) is used to support
DFU services in both configurations.
The only possible value for the MaxPacketSize in the DFU configuration is 32 Bytes,
which is the size of the FIFO implemented for endpoint 0.
USB Mass Storage Class Bulk-only Transport, Revision 1.0 - September 31, 1999
USB Human Interface Device Class, Version 1.1 - April 7, 1999
USB Device Firmware Upgrade Class, Revision 1.0 - May 13, 1999
Endpoint 0: 32 Bytes, Control In-Out
Endpoint 1: 64 Bytes, Bulk-in
Endpoint 2: 64 Bytes, Bulk-out
Endpoint 0: 32-Byte FIFO, default control endpoint
Endpoint 1, 2: 64-Byte Ping-pong FIFO,
4109E–8051–06/03