SAM3U2E Atmel Corporation, SAM3U2E Datasheet - Page 194

• Manufacturer Part Number: SAM3U2E
• Manufacturer: Atmel Corporation

Specifications of SAM3U2E

• Flash (kbytes): 128 Kbytes
• Pin Count: 144
• Max. Operating Frequency: 96 MHz
• Cpu: Cortex-M3
• # Of Touch Channels: 57
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 1
• Quadrature Decoder Channels: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device
• Spi: 5
• Twi (i2c): 2
• Uart: 5
• Ssc: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 16
• Adc Resolution (bits): 12
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 36
• Self Program Memory: YES
• External Bus Interface: 1
• Dram Memory: No
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

• MONITORACT
Debug monitor active bit, reads as 1 if Debug monitor is active
• SVCALLACT
SVC call active bit, reads as 1 if SVC call is active
• USGFAULTACT
Usage fault exception active bit, reads as 1 if exception is active
• BUSFAULTACT
Bus fault exception active bit, reads as 1 if exception is active
• MEMFAULTACT
Memory management fault exception active bit, reads as 1 if exception is active
If you disable a system handler and the corresponding fault occurs, the processor treats the fault as a hard fault.
You can write to this register to change the pending or active status of system exceptions. An OS kernel can write to the
active bits to perform a context switch that changes the current exception type.
194
• Software that changes the value of an active bit in this register without correct adjustment to the stacked content can
• After you have enabled the system handlers, if you have to change the value of a bit in this register you must use a read-
cause the processor to generate a fault exception. Ensure software that writes to this register retains and subsequently
restores the current active status.
modify-write procedure to ensure that you change only the required bit.
SAM3U Series
6430E–ATARM–29-Aug-11