SAM3U2E Atmel Corporation, SAM3U2E Datasheet - Page 153

• Manufacturer Part Number: SAM3U2E
• Manufacturer: Atmel Corporation

Specifications of SAM3U2E

• Flash (kbytes): 128 Kbytes
• Pin Count: 144
• Max. Operating Frequency: 96 MHz
• Cpu: Cortex-M3
• # Of Touch Channels: 57
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 1
• Quadrature Decoder Channels: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device
• Spi: 5
• Twi (i2c): 2
• Uart: 5
• Ssc: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 16
• Adc Resolution (bits): 12
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 36
• Self Program Memory: YES
• External Bus Interface: 1
• Dram Memory: No
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

13.17.2
13.17.2.1
13.17.2.2
13.17.2.3
13.17.2.4
13.17.2.5
6430E–ATARM–29-Aug-11
CPSID i
CPSID f
CPSIE i
CPSIE f
CPS
Syntax
Operation
Restrictions
Condition flags
Examples
; Disable interrupts and configurable fault handlers (set PRIMASK)
; Disable interrupts and all fault handlers (set FAULTMASK)
; Enable interrupts and configurable fault handlers (clear PRIMASK)
; Enable interrupts and fault handlers (clear FAULTMASK)
Change Processor State.
where:
effect
iflags
CPS changes the PRIMASK and FAULTMASK special register values. See
registers” on page 62
The restrictions are:
This instruction does not change the condition flags.
• use CPS only from privileged software, it has no effect if used in unprivileged software
• CPS cannot be conditional and so must not be used inside an IT block.
CPSeffect iflags
IE
ID
i
f
is one of:
Clears the special purpose register.
Sets the special purpose register.
is a sequence of one or more flags:
Set or clear PRIMASK.
Set or clear FAULTMASK.
for more information about these registers.
SAM3U Series
“Exception mask
153