WG82574L S LBA8 Intel, WG82574L S LBA8 Datasheet - Page 157
WG82574L S LBA8
Manufacturer Part Number
WG82574L S LBA8
Description
Manufacturer
Intel
Datasheet
1.WG82574L_S_LBA8.pdf
(472 pages)
Specifications of WG82574L S LBA8
Operating Supply Voltage (typ)
3.3V
Operating Temp Range
0C to 85C
Operating Temperature Classification
Commercial
Mounting
Surface Mount
Pin Count
64
Lead Free Status / RoHS Status
Compliant
- Current page: 157 of 472
- Download datasheet (3Mb)
Inline Functions—82574 GbE Controller
Note:
Note:
Note:
Note:
7.2.10.3
IPCSS - IP Checksum Start - Specifies the byte offset from the start of the DMA'd data
to the first byte to be included in the checksum. Setting this value to 0b means the first
byte of the data would be included in the checksum. This field is limited to the first 256
bytes of the packet and must be less than or equal to the total length of a given packet.
If this is not the case, the results are unpredictable.
IPCSO - IP Checksum Offset - Specifies where the resulting checksum should be
placed. This field is limited to the first 256 bytes of the packet and must be less than or
equal to the total length of a given packet. If this is not the case, the checksum is not
inserted.
IPCSE - IP Checksum End - Specifies where the checksum should stop. A 16-bit value
supports checksum off loading of packets as large as 64 KB. Setting the IPCSE field to
all zeros means EOP. In this way, the length of the packet does not need to be
calculated.
When doing checksum or TCP segmentation with IPv6 headers IPCSE field should be
set to 0x0000, IPCSS should be valid as in IPv4 packet and the IXSM bit in the data
descriptor should be cleared.
For proper IP checksum calculation, the IP Header Checksum field should be set to zero
unless some adjustment is needed by the driver.
Similarly, TUCSS, TUCSO, TUCSE specify the same parameters for the TCP or UDP
checksum.
For proper TCP/UDP checksum calculation the TCP/UDP Checksum field should be set to
the partial pseudo-header checksum value.
In case of 802.1Q header, the offset values depend on the VLAN insertion enable bit -
CTRL.VME. When the CTRL.VME is not set (VLAN tagging included in the packet
buffers), the offset values should include the VLAN tagging. When the CTRL.VME is set
(VLAN tagging is taken from the packet descriptor), the offset values should exclude
the VLAN tagging.
When setting the TCP segmentation context, IPCSS and TUCSS are used to indicate the
start of the IP and TCP headers respectively, and must be set even if checksum
insertion is not desired.
In certain situations, software might need to calculate a partial checksum (the TCP
pseudo-header for instance) to include bytes that are not contained within the range of
start and end. If this is the case, this partial checksum should be placed in the packet
data buffer, at the appropriate offset for the checksum. If no partial checksum is
required, software must write a value of zero at this offset.
Max Segment Size - MSS
MSS controls the maximum segment size. This specifies the maximum TCP or UDP
payload segment sent per frame, not including any header. The total length of each
frame (or section) sent by the TCP segmentation mechanism (excluding 802.3ac
tagging and Ethernet CRC) is MSS bytes + HRDLEN. The one exception is the last
packet of a TCP segmentation that might be shorter. This field is ignored if TDESC.TSE
is not set.
157
Related parts for WG82574L S LBA8
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
CONTROLLER, ENET, INTEL 82574L, 64PQFN
Manufacturer:
Intel
Datasheet:
Part Number:
Description:
Microprocessor: Intel Celeron M Processor 320 and Ultra Low Voltage Intel Celeron M Processor at 600MHz
Manufacturer:
Intel Corporation
Part Number:
Description:
Intel 82550 Fast Ethernet Multifunction PCI/CardBus Controller
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 120 ns
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 120 ns
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel StrataFlash memory 64 Mbit. Access speed 150 ns
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 100 ns
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
DA28F640J5A-1505 Volt Intel StrataFlash Memory
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
5 Volt Intel StrataFlash?? Memory
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
5 Volt Intel StrataFlash?? Memory
Manufacturer:
Intel Corporation
Part Number:
Description:
Intel 6300ESB I/O Controller Hub
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel 82801DB I/O Controller Hub (ICH4), Pb-Free SLI
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel 82801FB I/O Controller Hub (ICH6)
Manufacturer:
Intel Corporation
Datasheet: