zl50404 Zarlink Semiconductor, zl50404 Datasheet - Page 42

• Manufacturer Part Number: zl50404
• Description: Lightly Managed/unmanaged 5-port 10/100m Ethernet Switch
• Manufacturer: Zarlink Semiconductor

ZL50404
Data Sheet
1. Source or Destination MAC address based
2. Flow based
3. Port based
In source or destination mac address based mirroring, the “M” bit of the mirroring MAC address in the MCT is set.
Also, the user need to specify the mirroring MAC address is source or destination of the packet. If source is
selected, any packet received with the mirroring MAC address as source MAC address will be copied to the
mirrored port. In the same way, if destination is selected, any packet received with mirroring MAC address as
destination MAC address will be copied to the mirrored port.
In flow based mirroring, a flow is established based on the source and destination mac address pair. When
enabled, a packet with source and destination address match the pre-programmed source and destination mac
address pair will be copied to the mirrored port. In reverse direction (source and destination match pre programmed
destination and source), the flow can also be enabled and the frame will be copied to the mirrored port.
In port based mirroring, traffic from any RMAC port can be mirrored to any RMAC port. The traffic from the source
port can be either ingress or egress traffic. Up to two ports can be setup as mirrored ports. As a result, the traffic
(both ingress and egress) of a specific port can be monitored by setting up both mirrored ports. Once a port is setup
as mirrored port, it cannot be used for regular traffic.
The mirrored port can be any port in the ZL50404.
9.2
Using port mirroring for loop back
To perform remote loop back test, port mirroring can be used to bounce back the packet to the source port to check
the data path.
The CPU needs to setup the remote device through the command channel to enable port mirroring in the remote
device. A CPU packet is send to the port in test in Device A. The packet will be forwarded to the test port, external
cable, the destination port in Device B, and loop back to itself, back to the cable and go back to Device A and the
CPU. This way, the whole channel can be tested.
CPU
DEVICE B
DEVICE A
Figure 9 - Remote Loopback Test
10.0
GPSI (7WS) Interface
10.1
GPSI connection
The RMAC ethernet port can function in GPSI (7WS) mode. In this mode, the TXD[0], RXD[0] serve as TX data, RX
data and respectively. The link and duplex of the port can be controlled by programming the ECR register. Only
port-based VLAN is supported with GPSI interface.
42
Zarlink Semiconductor Inc.