h8s-2646 Renesas Electronics Corporation., h8s-2646 Datasheet - Page 732

• Manufacturer Part Number: h8s-2646
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
• Manufacturer: Renesas Electronics Corporation.

Section 20 ROM
20.8.3
In error protection, an error is detected when H8S/2646 runaway occurs during flash memory
programming/erasing, or operation is not performed in accordance with the program/erase
algorithm, and the program/erase operation is aborted. Aborting the program/erase operation
prevents damage to the flash memory due to overprogramming or overerasing.
If the LSI malfunctions during flash memory programming/erasing, the FLER bit is set to 1 in
FLMCR2 and the error protection state is entered. The FLMCR1, FLMCR2, EBR1, and EBR2
settings are retained, but program mode or erase mode is aborted at the point at which the error
occurred. Program mode or erase mode cannot be re-entered by re-setting the P or E bit. However,
PV and EV bit setting is enabled, and a transition can be made to verify mode.
FLER bit setting conditions are as follows:
1. When the flash memory of the relevant address area is read during programming/erasing
2. Immediately after exception handling (excluding a reset) during programming/erasing
3. When a SLEEP instruction (including software standby) is executed during
4. When the CPU releases the bus to the DTC
Error protection is released only by a reset and in hardware standby mode.
Rev. 5.00 Sep 22, 2005 page 706 of 1136
REJ09B0257-0500
(including vector read and instruction fetch)
programming/erasing
Error Protection