h8s-2646 Renesas Electronics Corporation., h8s-2646 Datasheet - Page 542

• Manufacturer Part Number: h8s-2646
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
• Manufacturer: Renesas Electronics Corporation.

Section 14 Smart Card Interface
14.3
14.3.1
The main functions of the Smart Card interface are as follows.
• One frame consists of 8-bit data plus a parity bit.
• In transmission, a guard time of at least 2 etu (Elementary Time Unit: the time for transfer of 1
• If a parity error is detected during reception, a low error signal level is output for one etu
• If the error signal is sampled during transmission, the same data is transmitted automatically
• Only asynchronous communication is supported; there is no clocked synchronous
14.3.2
Figure 14.2 shows a schematic diagram of Smart Card interface related pin connections.
In communication with an IC card, since both transmission and reception are carried out on a
single data transmission line, the TxD pin and RxD pin should be connected with the LSI pin. The
data transmission line should be pulled up to the V
When the clock generated on the Smart Card interface is used by an IC card, the SCK pin output is
input to the CLK pin of the IC card. No connection is needed if the IC card uses an internal clock.
LSI port output is used as the reset signal.
Other pins must normally be connected to the power supply or ground.
Rev. 5.00 Sep 22, 2005 page 516 of 1136
REJ09B0257-0500
bit) is left between the end of the parity bit and the start of the next frame.
period, 10.5 etu after the start bit.
after the elapse of 2 etu or longer. (except in block transfer mode)
communication function.
Operation
Overview
Pin Connections
CC
power supply with a resistor.