TMPM363F10FG Toshiba, TMPM363F10FG Datasheet - Page 543

• Manufacturer Part Number: TMPM363F10FG
• Manufacturer: Toshiba

Specifications of TMPM363F10FG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 1024K
• Rom Type: Flash
• Ram (kbytes): 64K
• Number Of Pins: 100
• Package: LQFP(14x14)
• Vcc: 3V
• Cpu Mhz: 64
• Ssp (ch) Spi: 1
• I2c/sio (ch): 4
• Uart/sio (ch): 5
• Usb: Host
• Can: 1
• Ethernet: -
• External Bus Interface: Y
• Cs/wait Controller (ch): 4
• Dma Controller: 2
• 10-bit Da Converter: 8
• 10-bit Ad Converter: 8
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 16
• Motor / Igbt Control: -
• Real Time Clock: Y
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: Y
• Remote Control Interface: Y
• Hardware Cec Controller: Y
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit

16.5.7
groups and each group has one interrupt output.
mailbox receive completion interrupt (INTCANRX) and the mailbox transmit completion interrupt (IN-
TCANTX), which are dependent on mailbox settings.
mailbox receive interrupt flag register (CANMBRIF) and one for the mailbox transmit interrupt flag register
(CANMBTIF). In addition, there is the mailbox interrupt mask register (CANMBIM) for setting whether to en-
able or disable each mailbox interrupt. The CANMBIM register is used both for transmit and receive mailboxes.
The CAN controller has the following interrupt sources. And these interrupt sources are divided into three
For mailbox interrupts, there are two interrupt output lines separated from global interrupts. These are the
There are two interrupt flag registers and one interrupt mask register. One interrupt flag register is for the
Figure 16-6 shows the block diagram of CAN interrupt signal.
Interrupt Control
・ CAN transmit completion interrupt (INTCANTX)
・ CAN receive completion interrupt (INTCANRX)
・ CAN Global interrupt (INTCANGB)
Transmit interrupt
Receive interrupt
Warning level interrupt
Error passive interrupt
Bus off interrupt
Time stamp overflow interrupt
Transmit abort interrupt
Receive message lost interrupt
Walk-up interrupt
Remote frame receive interrupt
It occurs at the completion of transmission
It occurs at the completion of reception
It occurs by eight sources other than those above.
Sources
:a message has been transmitted successfully.
:a message has been received successfully.
: at least one of the two error counters is great-
er than or equal to 97.
:CAN enters the error passive mode.
:CAN enters the bus off mode.
:after walk-up from sleep mode, this interrupt
will be generated.
Page 517
INTCANRX
INTCANGB
INTCANTX
Group
TMPM363F10FG