SAM9G20 Atmel Corporation, SAM9G20 Datasheet - Page 747

• Manufacturer Part Number: SAM9G20
• Manufacturer: Atmel Corporation

Specifications of SAM9G20

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 7
• Ssc: 1
• Ethernet: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 95
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

Figure 40-3. GOVRE and OVREx Flag Behavior
6384E–ATARM–05-Feb-10
(ADC_CHSR)
(ADC_CHSR)
ADC_LCDR
ADC_CDR0
ADC_CDR1
(ADC_SR)
(ADC_SR)
(ADC_SR)
(ADC_SR)
(ADC_SR)
GOVRE
ADTRG
DRDY
OVRE0
EOC0
EOC1
CH0
CH1
Undefined Data
Undefined Data
If the ADC_CDR is not read before further incoming data is converted, the corresponding Over-
run Error (OVRE) flag is set in the Status Register (ADC_SR).
In the same way, new data converted when DRDY is high sets the bit GOVRE (General Overrun
Error) in ADC_SR.
The OVRE and GOVRE flags are automatically cleared when ADC_SR is read.
Warning: If the corresponding channel is disabled during a conversion or if it is disabled and
then reenabled during a conversion, its associated data and its corresponding EOC and OVRE
flags in ADC_SR are unpredictable.
Conversion
Undefined Data
Conversion
Data A
Data A
Data B
Conversion
Data B
AT91SAM9G20
Data C
Read ADC_CDR1
Data C
Read ADC_CDR0
Read ADC_SR
747