3F88L-CG001N Omron, 3F88L-CG001N Datasheet - Page 185

• Manufacturer Part Number: 3F88L-CG001N
• Description: CABLE CAM OUTPUT-I/O BLOCK 1M
• Manufacturer: Omron

Specifications of 3F88L-CG001N

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 3F88LCG001N

Operation
5-3
Nothing appears on the display.
The ERROR terminal is H
The ERROR terminal is H.
Nothing appear on the display.
The ERROR terminal is L.
There are no cam outputs.
A specific cam output does not
turn ON.
Unprogrammed outputs are being
made.
p
ON
Troubleshooting
Problem
p
Power supply error.
RESET signal has been input.
Circuit error.
Watchdog timer error.
Display circuit error.
A cam program has not been
input.
Cam output power supply error.
BANK selection fault.
START signal input fault.
Control signal power supply fault.
Circuit error.
Wiring error.
Externally-connected part error.
Output transistor error.
A new cam program has been
input without clearing the existing
cam program.
When copying a cam program
from a 3F88L-160 Cam Positioner
to a 3F88L-162 Cam Positioner, a
cam program containing CAM17
to 32 has been input to the
3F88L-160 Cam Positioner (when
a cam program has been copied
to the 3F88L-160 from a
3F88L-162 beforehand.)
Program memory error.
Probable cause
Supply the correct power supply
voltage.
Check the connected wiring.
Replace the Cam Positioner.
Replace the Cam Positioner.
Check the cam program.
Check the power supply voltage.
Check the connected wiring.
Replace the Cam Positioner.
Check the connected wiring.
Replace the externally-connected
part.
Replace the Cam Positioner.
Check the cam program.
Check the cam program and
delete any unnecessary cam
programs.
Replace the Cam Positioner.
p
Possible solution
Chapter 5
5-9