3F88L-CG001N Omron, 3F88L-CG001N Datasheet - Page 109

• Manufacturer Part Number: 3F88L-CG001N
• Description: CABLE CAM OUTPUT-I/O BLOCK 1M
• Manufacturer: Omron

Specifications of 3F88L-CG001N

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 3F88LCG001N

Operation
• When the origin compensation value is “200” (resolution: 360)
H Related Parameters (SET Mode)
D Origin Compensation Value
• Use this parameter to set the present angle for when origin compensation or origin shift function is
• If this value is set to “0” (factory setting), the present angle will change to the origin (0°) when the origin
Note 1. The numeric values for 720 (divisions/rotation) resolution are shown in parentheses.
Note 2. This parameter is enabled when the power is turned OFF and then turned ON again.
Operation
• When the origin compensation value (Function No. b, Parameter No. 1) is displayed, the present set-
• Use the Forward, Up, and Down Keys to change the data.
• Press the Set Key and the data will remain lit for approximately one second, the setting will be con-
• If the data is inappropriate and the Set Key is pressed, all displays will flash twice and then return to the
• Press the Clear Key to return the data to the factory settings. If the Clear Key is pressed, the three
Function
No.
executed.
compensation or origin shift function is executed.
ting will be displayed in the SPEED/ON display and the first digit (rightmost digit) will flash.
firmed, and the display will resume flashing.
settings before the data was edited. Re-input the correct data.
digits of data will start flashing. Press the Set Key while the data is flashing and the display will change
to “-- -- --” and the factory settings will be restored. If the Clear Key is pressed again while the three digits
of data are flashing, the data will not be initialized and the display will return to the edited state.
Present angle before
compensation
Present angle after
compensation
b (
b
Use the mode selection switch to change to SET mode.
)
Origin
compensation
value
Parameter
No.
100
197
1
101
198
Backlash compensation value
102
199
Setting range 0 to 359 (0 to 719) (see note 1)
Y Execution position for origin
compensation/origin shift
103
200
104
201
105
202
Baud rate
Function level
106
203
Chapter 3
3-57
2