C200HW-BI101-V1 Omron, C200HW-BI101-V1 Datasheet - Page 81

• Manufacturer Part Number: C200HW-BI101-V1
• Description: BACKPLANE, 10 SLOT, I/O EXP
• Manufacturer: Omron

Specifications of C200HW-BI101-V1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Wiring
RUN Output
Crimp Terminals
DC Power Supplies
66
!
Caution
Note
Note
These terminals turn ON whenever the CPU Unit is operating in RUN or MON-
ITOR Mode. Use these terminals under the following specifications These termi-
nals are available on the C200HW-PA204R/PA209R only.
The terminals on the Power Supply Unit are M3.5, self-raising terminals with
screws. Use crimp terminals for wiring. Do not connect bare stranded wires
directly to terminals. Tighten the terminal block screws to the torque of 0.8 N S m.
Use round-type crimp terminals (M3.5) having the dimensions shown below.
Tighten the terminal block screws to the torque of 0.8 N S m. The loose screws
may result in short-circuit, malfunction, or burning.
Contact
form
Maximum
switching
capacity
1. Supply power to all of the Power Supply Units from the same source.
2. Be sure to check the setting of the voltage selector before supplying power.
3. Do not forget to remove the label from the top of the Power Supply Unit
1. Do not remove the protective label from the top of the Unit before wiring. This
2. After completing the wiring, remove the protective label from the top of the
C200HW-PD024
Power Supply Unit
Model
before turn on the power supply.
label is to prevent wiring clippings and other foreign matter from entering the
Unit during wiring procedures.
Unit before starting operation. The Unit will overheat if operated with this
label in place.
SPST-NO
250 VAC: 2 A for resistive loads
24VDC: 2 A
C200HW-PA204R
0.5 A for inductive loads
Note To satisfy the EC Directives (Low-voltage
7 mm max.
Screw (3.5 mm head with
self-raising pressure plate)
Directives), provide reinforced insulation or
double insulation for the 24-VDC power source
connected to the Power Supply Unit.
240 VAC: 2A for resistive loads
120 VAC: 0.5 A inductive loads
24 VDC: 2A
C200HW-PA209R
Section 3-2
DC power
source