C200HW-BI101-V1 Omron, C200HW-BI101-V1 Datasheet - Page 79

• Manufacturer Part Number: C200HW-BI101-V1
• Description: BACKPLANE, 10 SLOT, I/O EXP
• Manufacturer: Omron

Specifications of C200HW-BI101-V1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Wiring
AC Power Source
Voltage Selector
Isolation Transformer
Current Consumption
24-VDC Output
64
• Supply 100 to 120 or 200 to 240 VAC.
• Keep voltage fluctuations within the specified range
• If one power supply phase of the equipment is grounded, connect the
Shorted: 100 to 120 VAC
Open:
Short-circuit the voltage selection terminals with the shorting bracket supplied
as an accessory to select 100 to 120 VAC supply voltage. For 200 to 240 VAC
leave them open.
Noise between the PC and ground can be significantly reduced by connecting a
1-to-1 isolation transformer. Do not ground the secondary coil of the transformer.
The current consumption will be 120 VA max. (180 VA max. with the C200HW-
PA209) per Rack, and there will be a surge current of at least 5 times the max.
current when power is turned on.
Use these terminals as the power supply for 24-VDC Input Units. Never exter-
nally short these terminals; PC operation will stop if these terminals are shorted.
These terminals are available on the C200HW-PA204S only.
Although the 24-VDC output can supply up to 0.8 A, the combined power con-
sumption for both 5 V and 26 V must be 30 W or less, i.e., the capacity of the
24-VDC output will be reduced if the Units mounted to the Rack consume a lot of
current. Refer to Appendix C Unit Current and Power Consumption for the con-
sumption current of each Unit.
C200HW-PA204R or
C200HW-PA209R
Power Supply Unit
grounded phase side to the L
100 to 120 VAC
200 to 240 VAC
Supply voltage
200 to 240 VAC
RUN
OUTPUT
Power
supply
Voltage selector
85 to 132 VAC
170 to 264 VAC
Allowable voltage fluctuations
Screw (3.5 mm head with
self-raising pressure plate)
2
/N (or L
RUN output
1
/N if so indicated) terminal.
1:1 isolation
transformer
Section 3-2
AC power
source