TMOV25SP385M Littelfuse Inc, TMOV25SP385M Datasheet - Page 89

TMOV VARISTOR PB FREE 25S

TMOV25SP385M

Manufacturer Part Number
TMOV25SP385M
Description
TMOV VARISTOR PB FREE 25S
Manufacturer
Littelfuse Inc
Series
iTMOV®r
Datasheets

Specifications of TMOV25SP385M

Varistor Voltage
682V
Current-surge
20kA
Number Of Circuits
1
Maximum Ac Volts
385VAC
Energy
430J
Package / Case
Disc 25mm 3-Lead
Suppressor Type
Varistor
Peak Surge Current @ 8/20µs
20000A
Varistor Case
25mm DISC
Clamping Voltage Vc Max
1010V
Peak Energy (10/1000us)
430J
Voltage Rating Vdc
682V
Voltage Rating Vac
385V
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Maximum Dc Volts
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
©2009 Littelfuse, Inc.
Specifications are subject to change without notice.
Please refer to www.littelfuse.com/series/tmov.html for current information.
Rated AC Voltage (V
Maximum Non-Repetitive Surge Current (I
Nominal Discharge Current (I
Voltage Protection Rating (V
Part Numbering System
Term Definitions
This is the maximum peak current which may be applied
for a single 8/20μs impulse, with rated line voltage also
applied, without causing device failure. The pulse can
be applied to the device in either polarity with the same
confidence factor.
Peak value of the current, selected by the manufacturer,
through the SPD having a current waveshape of 8/20μs
where the SPD remains functional after 15 surges.
A rating selected from a list of preferred values as given
in UL 1449 and assigned to each mode of protection. The
value of VPR is determined as the nearest highest value
taken from UL 1449 to the measured limiting voltage
determined during the transient-voltage surge suppression
test using the combination wave generator at a setting of
6kV, 3kA.
This is the maximum continuous sinusoidal RMS voltage
that may be applied. This voltage may be applied at any
temperature up to the maximum operating temperature
of the device.
DEVICE FAMILY
Littelfuse thermally responsive MOV
DISC DIAMETER (mm)
2 mm
CERAMIC SHAPE
S: Square
M(AC)RMS
) – MCOV
PR
N
)
)
TMOV 2
Varistor Products
Radial Lead Varistors > TMOV25S
TM
)
S P 1 0 M
Revision: November 5, 2009
85
Maximum Non-Repetitive Surge Energy (W
Nominal Voltage (V
UL 1449
Limited Current Abnormal Over-voltage Test
An Underwriters Laboratory standard covering the safety
requirements for Surge Protective Devices intended for
permanently connected, cord-connected and direct plug-in
applications.
An AC over-voltage condition applied to a Surge Protective
Device according to UL 1449, Section 39.4. The short
circuit current is limited by series connected resistors
to 10A, 5A, 2.5A, 0.5A and 0.125A. The condition is
maintained for 7 hours or until the device under test
is disconnected from the AC supply or the current or
temperature reaches equilibrium.
This is the maximum rated transient energy which may be
dissipated for a single current pulse at a specified impulse
duration, with the rated RMS voltage applied, without
causing device failure.
This is the voltage at which the device changes from the
off (standby state) to the on (clamping state) and enters
its conduction mode of operation. The voltage value is
usually characterised at the 1mA point and has a specified
minimum and maximum voltage range.
SERIES DESIGNATOR
M: 3–Leaded Part
V
11 V O 7 0V
P: LEAD-FREE AND RoHS
COMPLIANT OPTION
M(AC)RMS                
TM
Series
N(DC)
)
TMOV
®
and i TMOV
®
Varistor Series
TM
)

Related parts for TMOV25SP385M