101-1279 Rabbit Semiconductor, 101-1279 Datasheet - Page 106

• Manufacturer Part Number: 101-1279
• Description: PLASTIC ENCLOSURE FOR BL4S100
• Manufacturer: Rabbit Semiconductor

Specifications of 101-1279

• Accessory Type: Enclosure
• Product: Prototyping Accessories
• Processor Type: BL4S100
• Board Size: 146 mm x 96 mm x 16 mm
• Interface Type: Ethernet
• For Use With/related Products: BL4S100
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 316-1159

An Introduction to ZigBee provides background information on the ZigBee protocol, and
is available on the CD and on our
6.2 ZigBee Sample Programs
In order to run the sample programs discussed in this chapter and elsewhere in this manual,
1. Dynamic C must be installed and running on your PC.
2. The programming cable must connect the programming header on the BL4S100 or the
3. Power must be applied to the BL4S100/Bl4S150.
4. The Digi
Refer to Chapter 2, “Getting Started,” if you need further information on these steps.
To run a sample program, open it with the
and run it by pressing
Each sample program has comments that describe the purpose and function of the pro-
gram. Follow the instructions at the beginning of the sample program.
The sample programs in the Dynamic C
ZigBee function calls.
BL4S100 User’s Manual
The XBee RF module used by the BL4S100 and the
BL4S150 presently supports using them in a mesh network.
BL4S100 and the BL4S150 boards are preconfigured with
ZB router firmware; coordinator and end-device firmware
are included in the Dynamic C installation along with a
sample program to allow you to download the firmware.
The firmware used with the XBee RF modules on the
BL4S100 and the BL4S150 is based on the API com-
mand set.
BL4S150 to your PC.
able USB port on your PC if you are exercising the ZigBee protocol.
NOTE: The Digi XBee USB device is an optional accessory and is not a part of the stan-
dard BL4S200 Tool Kit. See section F.2 Digi® XBee USB Configuration for more
information on the Digi XBee USB device.
®
XBee USB used as the ZigBee coordinator must be connected to an avail-
F9
.
Web
site.
SAMPLES\XBee
File
menu (if it is not still open), then compile
folders illustrate the use of the
Figure 19. Mesh Network
104