PEB3086HV14XP Infineon Technologies, PEB3086HV14XP Datasheet - Page 207

• Manufacturer Part Number: PEB3086HV14XP
• Manufacturer: Infineon Technologies

Specifications of PEB3086HV14XP

• Control Interface: HDLC
• Lead Free Status / Rohs Status: Compliant

SDS_
CONF
MCDA
4.4.13
Value after reset: 00
For general information on SDS1/2_BCL please refer to
DIOM_INV ... DU/DD on IOM Timeslot Inverted
0: DU/DD are active during SDS1 HIGH phase and inactive during the LOW phase.
1: DU/DD are active during SDS1 LOW phase and inactive during the HIGH phase.
This bit has only effect if DIOM_SDS is set to ’1’ otherwise DIOM_INV is don’t care.
DIOM_SDS ... DU/DD on IOM Controlled via SDS1
0: The pin SDS1 and its configuration settings are used for serial data strobe only.
1: The DU/DD lines are deactivated during the during High/Low phase (selected via
SDSx_BCL ... Enable IOM Bit Clock for SDSx
0: The serial data strobe is generated in the programmed timeslot.
1: The IOM bit clock is generated in the programmed timeslot.
4.4.14
Value after reset: FF
MCDAxy ... Monitoring CDAxy Bits
Bit 7 and Bit 6 of the CDAxy registers are mapped into the MCDA register.
This can be used for monitoring the D-channel bits on DU and DD and the ’Echo bits’ on
the TIC bus with the same register
Data Sheet
The IOM-2 data lines are not affected.
DIOM_INV) of the SDS1 signal. The SDS1 timeslot is selected in SDS1_CR.
7
7
SDS_CONF - Configuration Register for Serial Data Strobes
MCDA - Monitoring CDA Bits
Bit7
MCDA21
0
Bit6
H
H
0
Bit7
0
MCDA20
Bit6
0
207
DIOM_
Bit7
INV
MCDA11
DIOM_
SDS
Bit6
Detailed Register Description
Chapter
SDS2_
BCL
Bit7
MCDA10
0
0
3.7.2.
SDS1_
BCL
Bit6
RD/WR (5A)
PEB 3086
2003-01-30
ISAC-SX
RD (5B)