FW82801DBM S L6DN Intel, FW82801DBM S L6DN Datasheet - Page 127

• Manufacturer Part Number: FW82801DBM S L6DN
• Manufacturer: Intel

Specifications of FW82801DBM S L6DN

• Lead Free Status / RoHS Status: Not Compliant

5.8.4
5.8.4.1
Intel
®
82801DBM ICH4-M Datasheet
PCI Message-Based Interrupts
Theory of Operation
The following scheme is only supported when the internal I/O(x) APIC is used (rather than just the
8259).
The ICH4 supports the new method for PCI devices to deliver interrupts as write cycles, rather than
using the traditional PIRQ[A:D] signals. Essentially, the PCI devices are given a write path directly
to a register that will cause the desired interrupt. This mode is only supported when the ICH4’s
internal I/O APIC is enabled. Upon recognizing the write from the peripheral, the ICH4 sends the
interrupt message to the processor using the I/O APIC’s serial bus.
The interrupts associated with the PCI Message-based interrupt method must be set up for edge
triggered mode, rather than level triggered, since the peripheral only does the write to indicate the
edge.
The following sequence is used:
Because they are edge-triggered, the interrupts that are allocated to the PCI bus for this scheme
may not be shared with any other interrupt (e.g., the standard PCI PIRQ[A:D], those received via
SERIRQ#, or the internal level-triggered interrupts such as SCI or TCO).
The ICH4 ignores interrupt messages sent by PCI masters that attempt to use IRQ0, 2, 8, or 13.
1. During PCI PnP, the PCI peripheral is first programmed with an address
2. To cause the interrupt, the PCI peripheral requests the PCI bus and when granted, writes the
3. If the PRQ bit in the APIC Version register is set, the ICH4 positively decodes the cycles (as a
4. The ICH4 decodes the binary value written to MESSAGE_ADDRESS and sets the appropriate
5. After sending the interrupt message to the processor, the ICH4 automatically clears the
(MESSAGE_ADDRESS) and data value (MESSAGE_DATA) that will be used for the
interrupt message delivery. For the ICH4, the MESSAGE_ADDRESS is the IRQ Pin
Assertion Register, which is mapped to memory location FEC0_0020h.
MESSAGE_DATA value to the location indicated by the MESSAGE_ADDRESS. The
MESSAGE_DATA value indicates which interrupt occurred. This MESSAGE_DATA value is
a binary encoded. For example, to indicate that interrupt 7 should go active, the peripheral
writes a binary value of 0000111. The MESSAGE_DATA is a 32-bit value, although only the
lower 5 bits are used.
slave) in medium time.
IRR bit in the internal I/O APIC. The corresponding interrupt must be set up for edge-
triggered interrupts. The ICH4 supports interrupts 00h through 23h. Binary values outside this
range will not cause any action.
interrupt.
Functional Description
127