XRT83SL38ES Exar, XRT83SL38ES Datasheet - Page 88

• Manufacturer Part Number: XRT83SL38ES
• Description: Peripheral Drivers & Components - PCIs 8 CHT1/E1LIUSH
• Manufacturer: Exar

Specifications of XRT83SL38ES

• Product Category: Peripheral Drivers & Components - PCIs
• Rohs: yes

REV. 1.0.2
REVISIONS
EXAR Corporation reserves the right to make changes to the products contained in this publication in order to
improve design, performance or reliability. EXAR Corporation assumes no responsibility for the use of any
circuits described herein, conveys no license under any patent or other right, and makes no representation that
the circuits are free of patent infringement. Charts and schedules contained here in are only for illustration
purposes and may vary depending upon a user’s specific application. While the information in this publication
has been carefully checked; no responsibility, however, is assumed for inaccuracies.
EXAR Corporation does not recommend the use of any of its products in life support applications where the
failure or malfunction of the product can reasonably be expected to cause failure of the life support system or
to significantly affect its safety or effectiveness. Products are not authorized for use in such applications unless
EXAR Corporation receives, in writing, assurances to its satisfaction that: (a) the risk of injury or damage has
been minimized; (b) the user assumes all such risks; (c) potential liability of EXAR Corporation is adequately
protected under the circumstances.
Copyright 2007 EXAR Corporation
Datasheet June 2007.
Reproduction, in part or whole, without the prior written consent of EXAR Corporation is prohibited.
P1.0.0
P1.0.3
P1.0.4
P1.0.5
P1.0.6
P1.0.7
P1.0.8
P1.0.9
P1.1.0
R
P101
P102
1.0.0
1.0.1
1.0.2
EV
#
OCTAL T1/E1/J1 SH TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR
Initial data sheet
Edits
Reformatted columns.
corrected microprocessor timing information and edited Redundancy section.
Made edits to RLOS section. Table 4, EQC4 and EQC3 changed. RX transformer changed from 2:1 to 1:1.
Removed references to 1:2.42 transformer ratio.
Definition of TXON_n pin changed. Added detailed explanation of LOS operation. Added description of
arbitrary pulse. Added description of the operation of the TRATIO bit. Added description of Gap Clock Sup-
port.
Changed issue date to November 2002. Corrected BGA pinout.
Swapped the function of µPTS1 and µPTS2. Replaced µProcessor timing diagrams and timing information,
(Figures 27 and 28 -- Tables 50 and 51).
Removed EXT_VCM_[0-7] and made them No Connect pins. MCLKT1 changed to pin K1, TGND_0
changed to pin D3 and D3 made NC. SR_DR moved to pin K4.
Added RXON_n to bit 5 Control register 0.
Added new E1 arbitrary pulse feature. Added description to the global registers.
Final release.
Added (Exar recommends initiating a HW reset upon power up.) to the Hardware rest pin description. In fig-
ure 30 and in tables 51 and 52 changed t9 to 10 (µs). Changed format to add new logo.
Remove XRT83SL38IV product info.
NOTICE
86
D
ESCRIPTION
XRT83SL38