HD6437101 RENESAS [Renesas Technology Corp], HD6437101 Datasheet - Page 269

no-image

HD6437101

Manufacturer Part Number
HD6437101
Description
32-Bit RISC Microcomputer
Manufacturer
RENESAS [Renesas Technology Corp]
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
HD6437101A01FV
Manufacturer:
RENESAS
Quantity:
370
Part Number:
HD6437101A01FV
Manufacturer:
RENESAS
Quantity:
1 000
Part Number:
HD6437101A01FV
Manufacturer:
RENESAS
Quantity:
1 000
Part Number:
HD6437101A01FV
Manufacturer:
RENESAS/瑞萨
Quantity:
20 000
Company:
Part Number:
HD6437101A01FV
Quantity:
596
Part Number:
HD6437101A03FV
Manufacturer:
RENESAS
Quantity:
1 426
Part Number:
HD6437101A03FV
Manufacturer:
RENESAS
Quantity:
1 000
Part Number:
HD6437101A05FV
Quantity:
24 070
Part Number:
HD6437101A05FV
Manufacturer:
RENESAS
Quantity:
1 000
8.8.4
• When making a transition to a mode (Normal, PWM1, PWM2, PCM) in which the pin output
• In PWM mode 1, since a waveform is not output to the TIOC*B (TIOC *D) pin, setting TIOR
• In PWM mode 2, since a waveform is not output to the cycle register pin, setting TIOR will
• In normal mode or PWM mode 2, if TGRC and TGRD operate as buffer registers, setting
• In PWM mode 1, if either TGRC or TGRD operates as a buffer register, setting TIOR will not
• When making a transition to a mode (CPWM, RPWM) in which the pin output level is
Pin initialization procedures are described below for the numbered combinations in table 8.43. The
active level is assumed to be low.
Note: Channel number is substituted for * indicated in this article.
level is selected by the timer I/O control register (TIOR) setting, initialize the pins by means of
a TIOR setting.
will not initialize the pins. If initialization is required, carry it out in normal mode, then switch
to PWM mode 1.
not initialize the pins. If initialization is required, carry it out in normal mode, then switch to
PWM mode 2.
TIOR will not initialize the buffer register pins. If initialization is required, clear buffer mode,
carry out initialization, and then set buffer mode again.
initialize the TGRC pin. To initialize the TGRC pin, clear buffer mode, carry out initialization,
then set buffer mode again.
selected by the timer output control register (TOCR) setting, switch to normal mode and
perform initialization with TIOR, then restore TIOR to its initial value, and temporarily disable
channel 3 and 4 output with the timer output master enable register (TOER). Then operate the
unit in accordance with the mode setting procedure (TOCR setting, TMDR setting, TOER
setting).
Overview of Initialization Procedures and Mode Transitions in Case of Error
during Operation, etc.
Section 8 Multifunction Timer Pulse Unit (MTU)
Rev.1.00 Sep. 18, 2008 Page 235 of 522
REJ09B0069-0100

Related parts for HD6437101