AMD-766AC AMD [Advanced Micro Devices], AMD-766AC Datasheet - Page 14

• Manufacturer Part Number: AMD-766AC
• Description: Peripheral Bus Controller
• Manufacturer: AMD [Advanced Micro Devices]

23167B – March 2001
3.7
Pin name and description
USBCLK. 48 MHz USB clock.
USBOC0#. USB over current detect 0. This is expected to become active
to report the occurrence of an over-current condition on the voltage
supplied to the USB ports.
USBP[3:0], USBN[3:0]. Analog; USB ports. These are four pairs of
differential USB signals. USBP[3:0] are the positive signals and
USBN[3:0] are the negative signals. These signals go into the high-
impedance state during sleep states; internal logic may detect USB resume
events while in these states and set the status bit, PM20[USB_RSM_STS].
3.8
Pin name and description
STRAPH[2:0]. These pins should be tied high through a pull-up resistor
(to VDD_AUX).
STRAPL[3:0]. These should be grounded on the system board.
TEST#. Scan, NAND tree, and high-impedance mode enable. See
section 9 for details.
3.9
See section 4.6.1.5 for a description of the system power states. The following power and ground planes are
connected to the IC through BGA pins.
VDD3. Main 3.3 volt supply. This plane is required to be valid in the FON and POS power states.
VDD_AUX. Auxiliary 3.3 volt plane. This plane is required to be valid in all system power states except MOFF.
The pins powered by these planes are: PWRBTN#, PWRON#, PME#, SMBUS[C,D], EXTSMI#, SLPBTN#, RI#,
PWRGD, PCIRST#, RPWRON, DCSTOP#, STRAPH[2:0], STRAPL1. All register bits that are on the VDD_AUX
plane are reset by the internal RST_SOFT pulse that is generated for about 30 milliseconds after VDD_AUX
becomes valid.
VDD_REF. 5.0 volt reference supply. This plane is required to be valid in all power states except MOFF. It is
expected that this plane is connected to a 5-volt power supply that is active in the SOFF (soft off) power state, i.e., the
5-volt version of VDD_AUX from the power supply is required for this pin.
VDD_RTC. Real-time clock 3.3 volt supply. This plane is required to be valid in all power states. It is typically
powered by a battery. It supplies power for the internal VDD_AL power plane when VDD_AUX is not valid.
VDD_USB. 3.3 volt supply filtered for the USB transceivers. This plane is required to be valid in all power states
except MOFF.
VSS. Main ground plane.
VSS_USB. Ground plane filtered for the USB transceivers.
Universal Serial Bus Interface
Miscellaneous Signals
Power And Ground
Preliminary Information
AMD-766
TM
IO cell
type
Input
Input
Analog VDD_
IO cell
Input
Input
Input
type
Peripheral Bus Controller Data Sheet
Power
plane
VDD3 -
VDD3 -
VDD_
VDD3
VDD3
Power
plane
AUX
USB
During
Reset
During
3-state 3-state 3-state
Reset
-
-
-
Post
Reset
-
-
Reset
Post
-
-
-
POS
-
-
POS
-
-
-
14