SAM7L128 Atmel Corporation, SAM7L128 Datasheet - Page 64

• Manufacturer Part Number: SAM7L128
• Manufacturer: Atmel Corporation

Specifications of SAM7L128

• Flash (kbytes): 128 Kbytes
• Pin Count: 144
• Max. Operating Frequency: 36 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 80
• Ext Interrupts: 80
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Twi (i2c): 1
• Uart: 3
• Segment Lcd: 40
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 460
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 6
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.8 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

Figure 13-7.
64
if (URSTEN = 0) and
AT91SAM7L128/64 Preliminary
Peripheral Access
(URSTIEN = 1)
Reset Controller Status and Interrupt
URSTS
NRSTL
rstc_irq
NRST
MCK
resynchronization
• SRCMP bit: This field indicates that a Software Reset Command is in progress and that no
• NRSTL bit: The NRSTL bit of the Status Register gives the level of the NRST pin sampled on
• URSTS bit: A high-to-low transition of the NRST pin sets the URSTS bit of the RSTC_SR
further software reset should be performed until the end of the current one. This bit is
automatically cleared at the end of the current software reset.
each MCK rising edge.
register. This transition is also detected on the Master Clock (MCK) rising edge (see
13-7). If the User Reset is disabled (URSTEN = 0) and if the interruption is enabled by the
URSTIEN bit in the RSTC_MR register, the URSTS bit triggers an interrupt. Reading the
RSTC_SR status register resets the URSTS bit and clears the interrupt.
2 cycle
resynchronization
2 cycle
RSTC_SR
read
6257A–ATARM–20-Feb-08
Figure