SAM7L128 Atmel Corporation, SAM7L128 Datasheet - Page 461

• Manufacturer Part Number: SAM7L128
• Manufacturer: Atmel Corporation

Specifications of SAM7L128

• Flash (kbytes): 128 Kbytes
• Pin Count: 144
• Max. Operating Frequency: 36 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 80
• Ext Interrupts: 80
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Twi (i2c): 1
• Uart: 3
• Segment Lcd: 40
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 460
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 6
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.8 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

Note:
6257A–ATARM–20-Feb-08
Polarity and alignment can be modified only when the channel is disabled.
Figure 32-6. Synchronized Period or Duty Cycle Update
To prevent overwriting the PWM_CUPDx by software, the user can use status events in order to
synchronize his software. Two methods are possible. In both, the user must enable the dedi-
cated interrupt in PWM_IER at PWM Controller level.
The first method (polling method) consists of reading the relevant status bit in PWM_ISR Regis-
ter according to the enabled channel(s). See
The second method uses an Interrupt Service Routine associated with the PWM channel.
Note:
Figure 32-7. Polling Method
Reading the PWM_ISR register automatically clears CHIDx flags.
End of Cycle
Acknowledgement and clear previous register state
The last write has been taken into account
PWM_CPRDx
Update of the Period or Duty Cycle
Writing in PWM_CUPDx
PWM_CUPDx Value
AT91SAM7L128/64 Preliminary
Writing in CPD field
PWM_ISR Read
1
User's Writing
CHIDx = 1
Figure
YES
PWM_CDTYx
0
32-7.
PWM_CMRx. CPD
461