S5935QF Applied Micro Circuits Corporation, S5935QF Datasheet - Page 140

• Manufacturer Part Number: S5935QF
• Manufacturer: Applied Micro Circuits Corporation

Specifications of S5935QF

• Package Type: PQFP
• Rad Hardened: No
• Lead Free Status / Rohs Status: Not Compliant

S5935 – PCI Product
FIFO PCI Interface (Initiator Mode)
The S5935 can act as an initiator on the PCI bus. This
allows the device to gain control of the PCI bus to
transfer data to or from the FIFO. Internal address and
transfer count registers control the number of PCI
transfers and the locations of the transfers. The follow-
ing paragraphs assume the proper registers and bits
are programmed to enable bus mastering.
Figure 74. PCI Read from a Full S5935 FIFO
Figure 75. PCI Read from an Empty S5935 FIFO (Target Disconnect)
140
DS1527
Add-on Signals
Add-on Signals
PCI Signals
PCI Signals
DEVSEL#
DEVSEL#
PCI_CLK
PCI_CLK
WRFULL
WRFULL
FRAME#
FRAME#
AD[31:0]
AD[31:0]
TRDY#
STOP#
TRDY#
STOP#
IRDY#
IRDY#
FWE
FWE
ADDR
ADDR
PCI read and write transfers from the S5935 are very
similar. The FIFO management scheme determines
when the S5935 asserts its PCI bus request (REQ#).
When bus grant (GNT#) is returned, the device begins
running PCI cycles. Once the S5935 controls the bus,
the FIFO management scheme is not important. It only
determines when PCI bus control is initially requested.
PCI bus reads and writes are always performed as
bursts by the S5935, if possible.
DATA
DATA
Target Disconnect with Retry
Revision 1.02 – June 27, 2006
AMCC Confidential and Proprietary
Data Book