NT30-KBA04 Omron, NT30-KBA04 Datasheet - Page 264

• Manufacturer Part Number: NT30-KBA04
• Description: ANTI GLARE COVER FOR NT31
• Manufacturer: Omron

Specifications of NT30-KBA04

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

6-3-1 Replacing the Battery
Maintenance of the NT30/30C
Procedure 1. Keep the power ON for at least 1 minute and then turn it OFF.
Reference
The NT30/30C uses a lithium battery to back up the memory contents.
The battery life is 5 years if the NT30/30C is used in a location where the ambient
temperature is 25_C. If the temperature at the location of use is higher than this,
the battery life will be shorter. Change the battery at suitable intervals in accor-
dance with the operating environment of the NT30/30C.
It is advisable to keep a spare battery so that the battery can be replaced immedi-
ately if replacement becomes necessary.
S Battery model
S Battery Replacement
S Battery Replacing Method
2. Open the battery cover on the left side of the rear face of the NT30/30C by
Unless the power is kept ON for at least 1 minute, the memory contents cannot
be retained for more than 5 minutes without a battery.
C500-BAT08
Replace the battery in the following cases. The battery must be replaced within
5 days.
- When 5 years have passed since the installation of a new battery.
- When the RUN indicator is lit in orange (during operation) or in red (when
- When the message “Battery Lowered” is displayed on switching ON the pow-
- When “Lowered” is displayed when the battery check in the I/O check menu
Replace the battery by following the procedure given below.
To protect the contents of the memory, the battery must be replaced in less than
5 minutes.
have engaged with the NT30/30C, and that the rear face of the backlight unit
is parallel with the rear face of the NT30/30C, as shown in the figure below.
stopped).
er or resetting the NT30/30C.
is performed.
getting a purchase on its upper edge with your fingernails and pulling it to-
ward you. Do not try to open the battery cover with a tool such as a screwdriv-
Part A
Condition of the catches, as seen
from above
When correctly installed
When correctly installed
Section
253
6-3