NT30-KBA04 Omron, NT30-KBA04 Datasheet - Page 102

• Manufacturer Part Number: NT30-KBA04
• Description: ANTI GLARE COVER FOR NT31
• Manufacturer: Omron

Specifications of NT30-KBA04

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Precautions to be Observed During the Screen Data Transmission
3-7
Switching to the RUN Mode
Starting the Operation
Starting the Operation
Reference
Reference
Caution
If screen data cannot be transmitted from the NT-series Support Tool properly,
check whether communication between the NT30/30C and NT-series Support
Tool (personal computer) is normal.
When any of the following or a system error occurs during the screen data trans-
mission, the transmitted screen data will not be registered correctly to the
NT30/30C. If an error message is displayed and the Run Mode cannot be se-
lected, the screen data memory needs to be initialized.
When the power to the NT30/30C is turned ON or reset, the screen data is
checked. However, if any of the above occurs during the screen data transmis-
sion, the screen may disappear and other unexpected problems may occur.
In the case of such problems, set DIP switch SW2 pin 4 to ON to initialize the
memory.
For the memory initialization by using the DIP switch, refer to the Initialization by
Using the DIP Switch (page 80).
After completing the screen data transmission, and setting the communication
conditions, connect the NT30/30C to the PC and start the operation.
Press the Quit touch switch in the System Menu. The start-up screen in the RUN
mode will be displayed.
If the NT30/30C has failed to start correctly; e.g., the start-up screen is not dis-
played, an error message is displayed, or the screen is not displayed at all, refer
to 6-2 Responding to Displayed Error Messages (page 249) and take appropri-
ate action.
Press the Abort touch switch on the NT30/30C when the screen data transmis-
sion is completed. Unless this touch switch is pressed, the screen data will not
be correctly registered. If the Abort touch switch is pressed during transmission,
the screen data will not be correctly registered.
Check the operation of screen data and ladder programs thoroughly before ac-
tually using them.
The start-up screen is the screen whose screen number is set for the screen
switching specification in the PT Status Control Area. If no screen data has been
registered at screen number, the “Screen not registered.” error message will be
displayed. For the screen number setting, refer to 4-3 Screen Display (page
131).
• The power to the NT30/30C is interrupted or the NT30/30C is reset.
• The power to the computer on which the NT-series Support Tool is running is
• The cable connecting the NT30/30C to the computer on which the NT-series
• The Cancel touch switch on the NT30/30C screen is pressed to end the trans-
• The Cancel button on the NT-series Support Tool is pressed to end the trans-
interrupted or the computer is reset.
Support Tool is running is disconnected or has a broken wire.
mission during screen data transfer.
mission.
Section
3-7
91