UPD78F0413GA-GAM-AX NEC, UPD78F0413GA-GAM-AX Datasheet - Page 258

• Manufacturer Part Number: UPD78F0413GA-GAM-AX
• Description: 8BIT UC, 32K FLASH, 1KB RAM, LCD
• Manufacturer: NEC

Specifications of UPD78F0413GA-GAM-AX

• Controller Family/series: UPD78F
• No. Of I/o's: 30
• Ram Memory Size: 1024Byte
• Cpu Speed: 10MHz
• No. Of Timers: 8
• No. Of Pwm: RoHS Compliant
• Core Size: 8bit
• Program Memory Size: 32KB
• Oscillator Type: External, Internal

258
<10> By performing the procedures above, an arbitrary carrier clock is obtained. To stop the count operation,
clear TMHE1 to 0.
If the setting value of the CMP01 register is N, the setting value of the CMP11 register is M, and the count
clock frequency is f
Cautions 1. Be sure to set the CMP11 register when starting the timer count operation (TMHE1 = 1)
Remarks 1. For the setting of the output pin, see 8.3 (3) Port mode register 3 (PM3).
Carrier clock output cycle = (N + M + 2)/f
Duty = High-level width/carrier clock output width = (M + 1)/(N + M + 2)
2. For how to enable the INTTMH1 signal interrupt, see CHAPTER 17
2. Set so that the count clock frequency of TMH1 becomes more than 6 times the count
3. Set the values of the CMP01 and CMP11 registers in a range of 01H to FFH.
4. The set value of the CMP11 register can be changed while the timer counter is
5. Be sure to set the RMC1 bit before the count operation is started.
FUNCTIONS.
after the timer count operation was stopped (TMHE1 = 0) (be sure to set again even if
setting the same value to the CMP11 register).
clock frequency of TM51.
operating. However, it takes the duration of three operating clocks (signal selected by
the CKS12 to CKS10 bits of the TMHMD1 register) since the value of the CMP11
register has been changed until the value is transferred to the register.
CNT
, the carrier clock output cycle and duty are as follows.
CHAPTER 8 8-BIT TIMERS H0, H1, AND H2
User’s Manual U18698EJ1V0UD
CNT
INTERRUPT