ATA5771-DK1 Atmel, ATA5771-DK1 Datasheet - Page 126

• Manufacturer Part Number: ATA5771-DK1
• Description: BOARD XMITTER FOR ATA5771 868MHZ
• Manufacturer: Atmel
• Type: Transmitterr

Specifications of ATA5771-DK1

• Frequency: 868MHz
• Maximum Frequency: 868 MHz
• Supply Voltage (max): 4 V
• Supply Voltage (min): 2 V
• Supply Current: 8.5 mA
• Product: RF Development Tools
• For Use With/related Products: ATA5771
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

4.18.3
4.18.3.1
126
Atmel ATA5771/73/74
Functional Descriptions
Three-wire Mode
The 4-bit counter can be both read and written via the data bus, and can generate an overflow
interrupt. Both the Serial Register and the counter are clocked simultaneously by the same
clock source. This allows the counter to count the number of bits received or transmitted and
generate an interrupt when the transfer is complete. Note that when an external clock source
is selected the counter counts both clock edges. In this case the counter counts the number of
edges, and not the number of bits. The clock can be selected from three different sources: The
USCK pin, Timer/Counter0 Compare Match or from software.
The Two-wire clock control unit can generate an interrupt when a start condition is detected on
the Two-wire bus. It can also generate wait states by holding the clock pin low after a start
condition is detected, or after the counter overflows.
The USI Three-wire mode is compliant to the Serial Peripheral Interface (SPI) mode 0 and 1,
but does not have the slave select (SS) pin functionality. However, this feature can be imple-
mented in software if necessary. Pin names used by this mode are: DI, DO, and USCK.
Figure 4-53. Three-wire Mode Operation, Simplified Diagram
Figure 4-53
Slave. The two Shift Registers are interconnected in such way that after eight USCK clocks,
the data in each register are interchanged. The same clock also increments the USI’s 4-bit
counter. The Counter Overflow (interrupt) Flag, or USIOIF, can therefore be used to determine
when a transfer is completed. The clock is generated by the Master device software by tog-
gling the USCK pin via the PORT Register or by writing a one to the USITC bit in USICR.
SLAVE
MASTER
Bit7
Bit7
shows two USI units operating in Three-wire mode, one as Master and one as
Bit6
Bit6
Bit5
Bit5
Bit4
Bit4
Bit3
Bit3
Bit2
Bit2
Bit1
Bit1
Bit0
Bit0
PORTxn
USCK
USCK
DO
DO
DI
DI
9137E–RKE–12/10