C8051F930DK Silicon Laboratories Inc, C8051F930DK Datasheet - Page 177

• Manufacturer Part Number: C8051F930DK
• Description: KIT DEV C8051F920,F921,F930,F931
• Manufacturer: Silicon Laboratories Inc
• Type: MCUr

Specifications of C8051F930DK

• Contents: Target Board, Power Adapter, USB Debug Adapter, Cables, Batteries, and Software
• Processor To Be Evaluated: C8051F930
• Processor Series: C8051F9xx
• Data Bus Width: 8 bit
• Interface Type: I2C, UART, SPI
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 0.9 V to 3.6 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: C8051F920, F921, F930, F931
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1473

16.9. DC-DC Converter Register Descriptions
The SFRs used to configure the dc-dc converter are described in the following register descriptions. The
reset values for these registers can be used as-is in most systems; therefore, no software intervention or
initialization is required.
SFR Definition 16.1. DC0CN: DC-DC Converter Control
SFR Page = 0x0; SFR Address = 0x97
Reset
Name
Type
7:6
2:0
Bit
Bit
5
4
3
MINPW[1:0] DC
VSEL[2:0]
Reserved
SWSEL
Name
SYNC
7
0
MINPW
R/W
Specifies the minimum pulse width.
00: No minimum duty cycle.
01: Minimum pulse width is 20 ns.
10: Minimum pulse width is 40 ns.
11: Minimum pulse width is 80 ns.
DC-DC Converter Switch Select.
Selects one of two possible converter switch sizes to maximize efficiency.
0: The large switches are selected (best efficiency for high output currents).
1: The small switches are selected (best efficiency for low output currents).
Reserved. Always Write to 0.
ADC0 Synchronization Enable.
When synchronization is enabled, the ADC0SC[4:0] bits in the ADC0CF register
must be set to 00000b. Behavior as described is valid in REVC and later devices.
0: The ADC is not synchronized to the dc-dc converter.
1: The ADC is synchronized to the dc-dc converter. ADC0 tracking is performed
during the longest quiet time of the dc-dc converter switching cycle and ADC0 SAR
clock is also synchronized to the dc-dc converter switching cycle.
DC
Specifies the target output voltage.
000: Target output voltage is 1.8 V.
001: Target output voltage is 1.9 V.
010: Target output voltage is 2.0 V.
011: Target output voltage is 2.1 V.
100: Target output voltage is 2.4 V.
101: Target output voltage is 2.7 V.
110: Target output voltage is 3.0 V.
111: Target output voltage is 3.3 V.
0
6
-
-
DC Converter Minimum Pulse Width.
DC Converter Output Voltage Select.
SWSEL
R/W
5
1
Reserved
R/W
Rev. 1.1
4
0
C8051F93x-C8051F92x
Function
SYNC
R/W
3
0
2
0
VSEL
R/W
1
0
0
1
177