FDC37B78X SMSC Corporation, FDC37B78X Datasheet - Page 43

• Manufacturer Part Number: FDC37B78X
• Description: Enhanced Super I/O Controller with ACPI Support/ Real Time Clock and Consumer IR
• Manufacturer: SMSC Corporation

OW
PCN
POLL
PRETRK
R
RCN
SC
SK
SRT
ST0
ST1
ST2
ST3
WGATE
Overwrite
Present Cylinder
Number
Polling Disable
Precompensation
Start Track
Number
Sector Address
Relative Cylinder
Number
Number of
Sectors Per Track
Skip Flag
Step Rate Interval The time interval between step pulses issued by the FDC.
Status 0
Status 1
Status 2
Status 3
Write Gate
TABLE 21 - DESCRIPTION OF COMMAND SYMBOLS
The bits D0-D3 of the Perpendicular Mode Command can only be
modified if OW is set to 1. OW id defined in the Lock command.
The current position of the head at the completion of Sense
Interrupt Status command.
When set, the internal polling routine is disabled. When clear,
polling is enabled.
Programmable from track 00 to FFH.
The sector number to be read or written. In multi-sector transfers,
this parameter specifies the sector number of the first sector to be
read or written.
Relative cylinder offset from present cylinder as used by the
Relative Seek command.
The number of sectors per track to be initialized by the Format
command. The number of sectors per track to be verified during a
Verify command when EC is set.
When set to 1, sectors containing a deleted data address mark will
automatically be skipped during the execution of Read Data. If
Read Deleted is executed, only sectors with a deleted address
mark will be accessed. When set to "0", the sector is read or
written the same as the read and write commands.
Programmable from 0.5 to 8 milliseconds in increments of 0.5 ms
at the 1 Mbit data rate. Refer to the SPECIFY command for actual
delays.
Registers within the FDC which store status information after a
command has been executed. This status information is available
to the host during the result phase after command execution.
Alters timing of WE to allow for pre-erase loads in perpendicular
drives.
43