SAM3SD8B Atmel Corporation, SAM3SD8B Datasheet - Page 282

• Manufacturer Part Number: SAM3SD8B
• Manufacturer: Atmel Corporation

16.4.6.1
16.4.6.2
16.4.7
282
282
SAM3S8/SD8
SAM3S8/SD8
Wake Up Sources
Supply Monitor Reset
Brownout Detector Reset
down the core power supply and released as soon as the core power supply is correctly
regulated.
There are two additional sources which can be programmed to activate vddcore_nreset:
The supply monitor is capable of generating a reset of the system. This can be enabled by set-
ting the SMRSTEN bit in the Supply Controller Supply Monitor Mode Register (SUPC_SMMR).
If SMRSTEN is set and if a supply monitor detection occurs, the vddcore_nreset signal is imme-
diately activated for a minimum of 1 slow clock cycle.
The brownout detector provides the bodcore_in signal to the SUPC which indicates that the volt-
age regulation is operating as programmed. If this signal is lost for longer than 1 slow clock
period while the voltage regulator is enabled, the Supply Controller can assert vddcore_nreset.
This feature is enabled by writing the bit, BODRSTEN (Brownout Detector Reset Enable) to 1 in
the Supply Controller Mode Register (SUPC_MR).
If BODRSTEN is set and the voltage regulation is lost (output voltage of the regulator too low),
the vddcore_nreset signal is asserted for a minimum of 1 slow clock cycle and then released if
bodcore_in has been reactivated. The BODRSTS bit is set in the Supply Controller Status Reg-
ister (SUPC_SR) so that the user can know the source of the last reset.
Until bodcore_in is deactivated, the vddcore_nreset signal remains active.
The wake up events allow the device to exit backup mode. When a wake up event is detected,
the Supply Controller performs a sequence which automatically reenables the core power
supply.
• a supply monitor detection
• a brownout detection
11090A–ATARM–10-Feb-12
11090A–ATARM–10-Feb-12