SAM9263 Atmel Corporation, SAM9263 Datasheet - Page 93

• Manufacturer Part Number: SAM9263
• Manufacturer: Atmel Corporation

Specifications of SAM9263

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Can: 1
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 96
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

4.8.5
4.8.6
ARM DDI 0165B
DLOCK
DnM[4:0]
DLOCK indicates to an arbiter that an atomic operation is being performed on the bus.
DLOCK is normally LOW, but is set HIGH to indicate that a
is being performed. These instructions perform an atomic read/write operation, and can
be used to implement semaphores.
If DLOCK is asserted in a cycle, then this indicates that there is another access in the
next cycle that must be locked to the first. In the case of a multi-master system, the
ARM processor must not be degranted the bus when a locked transaction is being
performed.
DnM[4:0] indicates the operating mode of the ARM9E-S. This bus corresponds to the
bottom five bits of the CPSR, unless a forced User mode access is being performed, in
which case DnM[4:0] indicates User mode. These bits are inverted with respect to the
CPSR.
Copyright © 2000 ARM Limited. All rights reserved.
SWP
or
SWPB
Memory Interface
instruction
4-17