SAM9263 Atmel Corporation, SAM9263 Datasheet - Page 272

• Manufacturer Part Number: SAM9263
• Manufacturer: Atmel Corporation

Specifications of SAM9263

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Can: 1
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 96
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

Debug in depth
C-32
If bit 3 of the control register is programmed to 0, the comparators examine the
instruction address, instruction data, and instruction control buses. In this case bits [2]
and [0] of the mask register must be set to don’t care (programmed to 1_1). The format
of the register in this case is as shown in Figure C-9.
Table C-5 Watchpoint control register for data comparison functions (continued)
Bit
number
6
7
8
Copyright © 2000 ARM Limited. All rights reserved.
Name
CHAIN
RANGE
ENABLE
Figure C-9 Watchpoint control register for instruction comparison
Function
Selects the chain output of another watchpoint unit in order to
implement some debugger requests. For example, breakpoint on
address YYY only when in process XXX.
In the ARM9E-S EmbeddedICE-RT logic, the CHAINOUT
output of watchpoint 1 is connected to the CHAIN input of
watchpoint 0. The CHAINOUT output is derived from a latch.
The address or control field comparator drives the write enable
for the latch and the input to the latch is the value of the data
field comparator. The CHAINOUT latch is cleared when the
control value register is written or when DBGnTRST is LOW.
Can be connected to the range output of another watchpoint
register. In the ARM9E-S EmbeddedICE-RT logic, the address
comparator output of watchpoint 1 is connected to the RANGE
input of watchpoint 0. This allows you to couple two
watchpoints for detecting conditions that occur simultaneously,
for example, for range-checking.
If a watchpoint match occurs, the internal DWPT signal is only
asserted when the ENABLE bit is set. This bit only exists in the
value register. It cannot be masked.
ARM DDI 0165B