ATUC64L4U Atmel Corporation, ATUC64L4U Datasheet - Page 81

• Manufacturer Part Number: ATUC64L4U
• Manufacturer: Atmel Corporation

Specifications of ATUC64L4U

• Flash (kbytes): 64 Kbytes
• Pin Count: 48
• Max. Operating Frequency: 50 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 17
• Hardware Qtouch Acquisition: Yes
• Max I/o Pins: 36
• Ext Interrupts: 36
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 2
• Uart: 4
• Lin: 4
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 12
• Adc Speed (ksps): 460
• Analog Comparators: 8
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.62 to 3.6
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 6
• Output Compare Channels: 18
• Input Capture Channels: 12
• Pwm Channels: 35
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

8.11
32002F–03/2010
Multiple data memory access instructions
These instructions perform multiple data accesses. The incremental accesses are performed as
word accesses. The number of cycles is dependent on the number of registers to load or store,
n. The issue latency must be modified as follows:
The instructions in this group will be aborted immediately if any interrupts are pending, in order
to limit the interrupt latency.
Table 8-8.
Mnemonics
ldm
ldm
ldmts
ldmts
popm
pushm
stm
stm
stmts
stmts
• LDM and POPM will use an additional cycle if testing of R12 is performed
• LDM and POPM that updates PC will cause a change-of-flow, which is performed in parallel
• The issue latency for HSB accesses increases if the HSB bus is busy or the slave inserts wait
with the pointer writeback and therefore has a penalty of only one cycle.
states.
Multiple data memory accesses
E
E
E
E
C
C
E
E
E
E
Operands
Rp, Reglist16
Rp++, Reglist16
Rp, Reglist16
Rp++, Reglist16
Reglist8
Reglist8
Rp, Reglist16
--Rp, Reglist16
Rp, Reglist16
--Rp, Reglist16
Description
Load multiple registers. R12 is
tested if PC is loaded. If PC is in the
register list, p=1, otherwise p=0.
Load multiple registers. R12 is
tested if PC is loaded.
Load multiple registers for task
switch.
Load multiple registers for task
switch.
Pop multiple registers from stack.
R12 is tested if PC is popped.
Store multiple registers.
Store multiple registers.
Store multiple registers for task
switch.
Store multiple registers for task
switch.
Push multiple registers to stack.
Issue
latency
IRAM
1+n+p
2+n
1+n
2+n
2+n
2+n
1+n
2+n
1+n
2+n
AVR32
Issue
latency
HSB
1+2n+p
1+2n
1+2n
1+2n
1+2n
3+n
2+n
3+n
2+n
3+n
81