ATUC64L4U Atmel Corporation, ATUC64L4U Datasheet - Page 112

• Manufacturer Part Number: ATUC64L4U
• Manufacturer: Atmel Corporation

Specifications of ATUC64L4U

• Flash (kbytes): 64 Kbytes
• Pin Count: 48
• Max. Operating Frequency: 50 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 17
• Hardware Qtouch Acquisition: Yes
• Max I/o Pins: 36
• Ext Interrupts: 36
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 2
• Uart: 4
• Lin: 4
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 12
• Adc Speed (ksps): 460
• Analog Comparators: 8
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.62 to 3.6
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 6
• Output Compare Channels: 18
• Input Capture Channels: 12
• Pwm Channels: 35
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

32002F–03/2010
The complete signal list of the AUX port is shown in Table 9-18.
Table 9-18.
Auxiliary
pins
MCKO
MDO
MSEO
EVTO
EVTI
RESET_
N
Width
1
6
2
1
1
1
Auxiliary pins
Direct
ion
O
O
O
O
I
I
Description
Message Clockout (MCKO) is a free-running output clock to
development tools for timing of MDO and MSEO pin functions.
Message Data Out (MDO[5:0]) are output pins used for all messages
generated by the device. In single datarate mode, external latching of
MDO shall occur on rising edge of MCKO. In double datarate mode,
external latching of MDO shall occur on both edges of MCKO.
Message Start/End Out (MSEO[1:0]) pins indicate when a message
on the MDO pins has started, when a variable length packet has
ended, and when the message has ended. In single datarate mode,
external latching of MSEO shall occur on rising edge of MCKO. In
double datarate mode, external latching of MSEO shall occur on both
edges of MCKO.
Event Out (EVTO) is an output pin which can be configured to toggle
every time a message is inserted into the Transmit Queue, when the
CPU entered OCD Mode, or when a breakpoint or watchpoint hit
occured, as configured by the EOS bits in the Development Control
register .
Event In (EVTI) is an input which, when a high-to-low transition occurs,
a processor is halted (breakpoint) or program and data
synchronization messages are transmitted from the OCD controller, as
configured by the EIC bits in the Development Control register.
System reset
AVR32
112