MC68HC908LD60IFU Freescale Semiconductor, MC68HC908LD60IFU Datasheet - Page 156

• Manufacturer Part Number: MC68HC908LD60IFU
• Manufacturer: Freescale Semiconductor

Specifications of MC68HC908LD60IFU

• Cpu Family: HC08
• Device Core Size: 8b
• Frequency (max): 6MHz
• Program Memory Type: Flash
• Program Memory Size: 60KB
• Total Internal Ram Size: 1KB
• # I/os (max): 39
• Number Of Timers - General Purpose: 2
• Operating Supply Voltage (typ): 3.3V
• Operating Supply Voltage (max): 3.6V
• Operating Supply Voltage (min): 3V
• On-chip Adc: 6-chx8-bit
• Instruction Set Architecture: CISC
• Operating Temp Range: 0C to 85C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 64
• Package Type: PQFP
• Lead Free Status / Rohs Status: Compliant

Timer Interface Module (TIM)
Technical Data
156
NOTE:
NOTE:
TOIE — TIM Overflow Interrupt Enable Bit
TSTOP — TIM Stop Bit
Do not set the TSTOP bit before entering wait mode if the TIM is required
to exit wait mode.
TRST — TIM Reset Bit
Setting the TSTOP and TRST bits simultaneously stops the TIM counter
at a value of $0000.
PS[2:0] — Prescaler Select Bits
overflow occurs before the clearing sequence is complete, then
writing logic zero to TOF has no effect. Therefore, a TOF interrupt
request cannot be lost due to inadvertent clearing of TOF. Reset
clears the TOF bit. Writing a logic one to TOF has no effect.
This read/write bit enables TIM overflow interrupts when the TOF bit
becomes set. Reset clears the TOIE bit.
This read/write bit stops the TIM counter. Counting resumes when
TSTOP is cleared. Reset sets the TSTOP bit, stopping the TIM
counter until software clears the TSTOP bit.
Setting this write-only bit resets the TIM counter and the TIM
prescaler. Setting TRST has no effect on any other registers.
Counting resumes from $0000. TRST is cleared automatically after
the TIM counter is reset and always reads as logic zero. Reset clears
the TRST bit.
These read/write bits select either the TCLK pin or one of the seven
prescaler outputs as the input to the TIM counter as
shows. Reset clears the PS[2:0] bits.
1 = TIM counter has reached modulo value
0 = TIM counter has not reached modulo value
1 = TIM overflow interrupts enabled
0 = TIM overflow interrupts disabled
1 = TIM counter stopped
0 = TIM counter active
1 = Prescaler and TIM counter cleared
0 = No effect
Timer Interface Module (TIM)
MC68HC908LD60
Freescale Semiconductor
Table 11-2
—
Rev. 1.1