CV500BC101 Omron, CV500BC101 Datasheet - Page 48

no-image

CV500BC101

Manufacturer Part Number
CV500BC101
Description
Programmable Logic Controller
Manufacturer
Omron
Datasheet

Specifications of CV500BC101

Peak Reflow Compatible (260 C)
No
Leaded Process Compatible
No
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Specifications and Configurations
1-2-6
Programming Device for the PLC
Programming Devices
Note
Note Normally, the communications cable must be disconnected from a Wired Con-
troller Link Unit to replace it. Doing this, however, will interrupt communica-
tions on the network, requiring that all node be turned OFF to ensure safety
before replacing a Unit. With the above Relay Terminal Block, a Controller
Link Unit can be replaced by turning OFF only the specific Unit being
replaced, i.e., without turning OFF any other Units. The communications
cables are left connected to the Relay Terminal Block and only the Relay Ter-
minal Block is removed from the Controller Link Unit. (The built-in terminating
resistance connected at the Units at the end of the network prevents using the
Relay Terminal Block on the end Units.) Refer to Appendix C Using the Relay
Terminal Block for details on using the Terminal Relay Block.
A Programming Device for the PLC, the Controller Link Support Software, or
CX-Programmer are needed to use a Controller Link Network.
One of the following Programming Devices is necessary when using the auto-
matically setting data links or the message service.
The following operations are possible.
1. Use the CX-Net in CX-Programmer version 5.0 or higher to set data link
CX-Programmer
(for PLC)
Programming
Console
• Selecting manual or automatic setting for data links.
• Setting the data link mode to “automatic” (software switch setting).
• Starting/stopping data links (Start Bit: ON/OFF)
• Programming for the message service.
• Reading (monitoring) the network status.
Programming
send and receive areas that exceed 12,000 words, and to set data link ta-
bles that allocate the same area for Area 1 and Area 2.
Device
IBM PC/AT or
compatible
Programming
Console
CX-Programmer
appearance
+
External
or
WS02-CXPC
V
CQM1-PRO01-E
C200H-PRO27-E
CVM1-PRS21-EV1
@
Software switches (DM Area)
Start-up node
Model
@
-E-
CPU Unit
Controller Link
CS/CJ-series,
C200HX/HG/HE,
CVM1-series, and
CQM1H-series PLCs
C200HX/HG/HE,
C200H/C200HS,
CQM1, and
CQM1H-series PLCs
CVM1 and
CV-series PLCs
Applicable PLCs
Section 1-2
23

Related parts for CV500BC101