MB9BF104RPMC-GE1 Fujitsu Semiconductor America Inc, MB9BF104RPMC-GE1 Datasheet - Page 5

• Manufacturer Part Number: MB9BF104RPMC-GE1
• Description: IC MCU 32BIT 256KB FLASH 120LQFP
• Manufacturer: Fujitsu Semiconductor America Inc
• Series: FM3 MB9B100r

Specifications of MB9BF104RPMC-GE1

• Core Processor: ARM® Cortex-M3™
• Core Size: 32-Bit
• Speed: 80MHz
• Connectivity: CSIO, EBI/EMI, I²C, LIN, UART/USART
• Peripherals: DMA, LVD, POR, PWM, WDT
• Number Of I /o: 100
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 16x12b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 120-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Other names: 865-1117

DS706-00007-1v0-E
 CRC (Cyclic Redundancy Check) Accelerator
 Clock and Reset
 Clock Super Visor (CSV)
 Low Voltage Detector (LVD)
 Low Power Mode
 Debug
 Power Supply
[Clocks]
[Resets]
The CRC accelerator helps a verify data transmission or storage integrity.
CCITT CRC16 and IEEE-802.3 CRC32 are supported.
・ CCITT CRC16 Generator Polynomial: 0x1021
・ IEEE-802.3 CRC32 Generator Polynomial: 0x04C11DB7
Five clock sources (2 ext. osc, 2 CR osc, and PLL) that are dynamically selectable.
・ Main Clock
・ Sub Clock
・ High-speed CR Clock : 4MHz
・ Low-speed CR Clock : 100kHz
・ PLL Clock
Reset requests from INITX pins, Power on reset, Software reset, watchdog timers reset, low voltage
detector reset and clock supervisor reset.
Clocks generated by CR oscillators are used to supervise abnormality of the external clocks.
・ External OSC clock failure (clock stop) is detected, reset is asserted.
・ External OSC frequency anomaly is detected, interrupt or reset is asserted.
MB9B100 Series include 2-stage monitoring of voltage on the VCC. When the voltage falls below the
voltage has been set, Low Voltage Detector generates an interrupt or reset.
・ LVD1: error reporting via interrupt
・ LVD2: auto-reset operation
Three power saving modes supported.
・ SLEEP
・ TIMER
・ STOP
・ Serial Wire JTAG Debug Port (SWJ-DP)
・ Embedded Trace Macrocells (ETM) provide comprehensive debug and trace facilities.
・ Trace Port Interface Unit (TPIU) for bridging to a Trace Port Analyzer.
Two Power Supplies
・ VCC = 2.7V to 5.5V: Correspond to the wide range voltage.
: 4 to 48MHz
: 32.768kHz
MB9B100 Series
5